GE TOP-FREEZER 16 Owner's Manual And Installation Instructions

Also see for 16: Owner's manual and installation instructions Owner's manual and installation instructions User guide Owner's Manual & Installation Instructions Owner's manual and installation instructions

Contents

GE TOP-FREEZER 16 Owner's Manual And Installation Instructions Manual pdf 7 page image

About storage drawer and cover removal. GEAppliances.comNot all features are on all models.Twin Drawer ShelfTo remove:Remove the drawers.Reach in, push the front of glass cover up,and at the same time, pull it forward as faras it will come.Tilt it and take it out. Avoid cleaning the cold glasscover with hot water because the extremetemperature difference may cause it to break.Remove the drawer frame. (Always removethe glass cover before you take out thedrawer frame.)Lift the frame off the supports at each side andback, pull it forward, tilt it and take it out.To replace:Lower the frame until it rests on thesupports at each side and back.Replace the glass cover, pushing its rearedge firmly into the rear frame channel andgently lowering the front into place.Replace the drawers.321321Drawer and Cover RemovalDrawers can be removed easily by grasping the sides and lifting up slightly while pulling drawerspast the stop location.Full-Width Drawer withPlastic CoverTo remove the cover, lift it off its supports,pull it forward, tilt it and take it out.Adjustable Humidity Drawer (on some models)Slide the control all the way to theHIGH setting to provide high humidityrecommended for most vegetables.Slide the control all the way to the LOWsetting to provide lower humidity levelsrecommended for most fruits.About the automatic icemaker.A newly-installed refrigerator may take 12 to 24 hours to begin making ice.Automatic Icemaker (on some models)The icemaker will produce approximately100–130 cubes in a 24-hour period, depending onthe freezer compartment temperature, roomtemperature, number of door openings and otheruse conditions.If the refrigerator is operated before the waterconnection is made to the icemaker, move thefeeler arm to the STOP (up) position.When the refrigerator has been connected tothe water supply, move the feeler arm to the ON(down) position.The icemaker will fill with water when it cools to15°F. A newly-installed refrigerator may take 12 to24 hours to begin making ice cubes.Once the icemaker starts to make ice,it may take up to 48 hours to fill the bin,depending on the temperature settingsand number of door openings.You will hear a buzzing sound each time theicemaker fills with water.Throw away the first few batches of iceto allow the water line to clear.Be sure nothing interferes with the sweep of thefeeler arm.When the bin fills to the level of the feeler arm,the icemaker will stop producing ice.It is normal for several cubes to be joinedtogether.If ice is not used frequently, old ice cubes willbecome cloudy, taste stale, shrink or fusetogether.On power switch models, the green power lightwill blink if ice cubes get stuck in the icemaker.To correct this, set the power switch to O (off)and remove the cubes. Set the power switch to I(on) to restart the icemaker. After the icemakerhas been turned on again, there will be a delayof about 45 minutes before the icemakerresumes operation.NOTE: In homes with lower-than-average waterpressure, you may hear the icemaker cycle multipletimes when making one batch of ice.Icemaker Accessory KitIf your refrigerator did not already come equippedwith an automatic icemaker, an icemakeraccessory kit is available at extra cost.Check the back of the refrigerator forthe specific icemaker kit needed foryour model.Feeler Arm inthe STOP(up) positionFeeler Arm inthe ON (down)position7There are 2 types of icemakers:Power switch modelFeeler arm modelPower SwitchGreen Power LightIcemakerFeeler Arm