GE UVC9300 Owner's Manual & Installation Instructions

Also see for UVC9300: Owner's Manual & Installation Instructions

829-6325LightsCAUTION Allow lights to cool before touching.1. Before attempting to replace the lights, make sure thatthe light switch is turned off.2. Rotate light counterclockwise to unlock and pull out.Wearing latex gloves may offer a better grip.3. Replace with new light of same type, making surepins are inserted properly into the sockets of the lampholder and turn clockwise to lock.All lamps need to be GU10 compatible.SurfacesCARE AND CLEANING: Surfaces / Lights / FiltersRotate the lamp until thepins are located in narrowneck of the socket to lock.LampHolderStainless Steel Surfaces (on some models)Do not use a steel wool pad; it will scratch thesurface.To clean the stainless steel surface, use warm sudsywater or a stainless steel cleaner or polish. Always wipethe surface in the direction of the brush line. Followthe cleaner instructions for cleaning the stainless steelsurface. Cleaners with oxalic acid such as Bar KeepersFriend Soft Cleanser™ willremove surface rust, tarnish, andsmall blemishes. To receive acoupon for a trial sample of BarKeepers Friend Soft Cleanser™follow the link below or scan theQR Code.barkeepersfriend.com/geUse only a liquid cleanser free of grit and rub in thedirection of the brush lines with a damp soft sponge.To inquire about purchasing stainless steel appliancecleaner or polish, or to find the location of a dealernearest you, please call our toll-free number:National Parts Center800.626.2002GEApplianceParts.comIn Canada, call 800.661.1616 or visitgeappliances.ca.Charcoal Filter (for recirculation installation only)NOTE: DO NOT rinse, or put charcoal filter in anautomatic dishwasher.The charcoal filter is included with the unit. It cannotbe cleaned; it must be replaced. It is recommendedthat the charcoal filter be replaced every 6 months orif it is noticeably dirty or discolored.Order Charcoal Filter UXCF91To inquire about purchasing replacement charcoal filtersor to find the location of a dealer nearest you, please callour toll-free number:National Parts Center 800.626.2002In Canada, call 800.661.1616.To Install1. Remove the grease filters. See Filters section.2. Install the charcoal filter mounts to either side of themotor using three screws per side.3. Insert the tab on the charcoal filter into the triangularslot on the mount.4. Clip the charcoal filter in until it is locked5. Repeat with second filter on the other side of themotor.6. Reattach the metal filters. See Filters section.To Remove1. Remove grease filters-See Filters section2. Unclip the charcoal filter by pressing the release clip.3. Carefully remove charcoal filter from tab.Filters (Cont.)Charcoal Filter Mount