IS059 (6/10)INSTALLATION INSTRUCTIONS FOR WR30X10093Ice MakerBefore you begin:Read these instructions completely and carefully. Wait 5minutes after the power has been disconnected beforebeginning the installation procedure.Remove items from the freezer to safely allow access forthe removal of the existing ice maker and the installationof the new ice maker.Tools needed:• Phillips head screwdriver• Flatblade screwdriver• 1/4" Hex head driverFor Metal Interior Lined Side-by-sideRefrigerators ONLY1. Remove the ice bucket and chiller shelf (if applicable).See Figure 1 & 2.2. Remove the existing ice maker.The ice maker will be attached to the ice maker bracketwith a Phillips head or Hex head screws. See Figure 3.For side-by-side refrigerator with no through the doorice dispenser• Using the appropriate screwdriver, loosen the 2mounting screws until the screw heads extend about1/2" (13mm) from the ice maker bracket. NOTE: Donot completely remove the screws.• Slide the ice maker upwards so that the screws arein the wide part of the mounting tab. Pull the icemaker away from the ice maker bracket. See Figure 1.• Unplug the ice maker from the socket located on therear wall of the freezer.To avoid risk of electrical shock,personal injury or death; disconnectelectrical power before servicing.WARNING! Electrical Shock HazardFIG. 3FIG. 1Non-DispenserSide-by-side BucketIce BucketMounting TabsFIG. 2DispenserSide-by-side BucketIce BucketChiller ShelfFor side-by-side refrigerator with a through the door icedispenser• Unscrew front screw, slide out ice maker by pullingtowards you from side wall. See Figure 4.• To unplug the ice maker, locate the restraints oneach side of the plug. Unclip the restraints by pullingoutward. See Figure 4.FIG. 4Unclip restraints bypinching the sideswith your handUnscrew front screw, slideout ice maker by pullingtowards you from sidewall