GE ZKW36V Installation Instructions Manual

Installation Instructions36” STANDARD INSTALLATIONGroundWirePowerCordStep 2Step 3CHANGE POWER CORDLonger power cords are required for standard install kitinstallation. Power cords are included in the StandardInstall Kit.Remove existing short power cord with stringassembly:Ŷ Remove 1/4” hex screws attaching rear access cover.1. Unplug 3-pin power cord connector inside themachine compartment (press on sides to releaselocking tabs).2. Remove power cord green ground 1/4” hex screw.3. Remove strain relief 1/4” hex screw.Install new longer power cord:1. Plug in the 3-pin connector (make sure locking tabsare engaged).2. Install the power cord green ground screw.3. Install the power cord strain relief.Ŷ Replace rear access cover. Make sure the powercord and ground wire are properly routed through theaccess cover cut-out.RearAccessCover3-PinPower CordConnector3-PinPower CordConnectorGreen GroundScrewStrain ReliefScrewStep 1Step 2Step 3WARNING Electrical Shock Hazard.To avoid the risk of electric shock, make sure to re-installthe ground screw after changing the power cord.AVERTISSEMENT Risque d’électrocution.Pour éviter le risque d’électrocution, assurez-vous deréinstaller la vis de mise à la terre après avoir changé lecordon d’alimentation.ADVERTENCIA Riesgo de DescargaEléctrica. A fin de evitar riesgos de descarga eléctrica,asegúrese de volver a instalar el tornillo de conexión a tierraluego de cambiar el cable de corriente.CASE TRIM INSTALLATIONŶ Install the trim kitside rails to theexposed right andleft case wallsusing the provided#8 Phillips headscrews - 15 screwsper side.Ŷ Fit the top trim and side trim rails together by slidingthe exposed edges of the corner trim into the right andleft trim kit side rails. Align and drive the two number10-24 Phillips head screws into the screw bosses inthe side rails to ensure the top trim is snugly fit to theside rails.Ŷ Secure the top trim to the case by using the provided#8 Phillips head screws (2 screws).331-1000725 Rev. 1