GE ZVC36L2SS Installation Instructions Manual

Also see for GE Monogram ZVC30: Installation instructions

Contents

Design InformationPRODUCT DIMENSIONSZVC30The custom cenopg must be sized to fit the insertsleeve. Construct the cenopg with en openingthat is:26'M/x 13-3/16"DThe opening must be constructed of :3/4" thickmaterial to allow the sleeve locking clips toengage.The Supplied Liner28-1/2"//21-1/4"The stainless steel liner is shipped with each hoodinsert. This non-combustible liner protects theunderside of the canopy.Custom LinerIf you are not using the supplied liner, you mayconstruct a custom non-combustible linen Use thesupplied liner as a template. The opening must be26"W x 13-3/16"D. 3/4" thick material mustsurround the opening to allow the sleeve lockingclips to engage. The insert sleeve inside the cabinetshould be positioned 1/2" from the rear wall sothat the center of the 8" duct is 5-1/2" from therear wall./2"Dimensions and Specifications (in inches)Outside Dimensions27-1/2"The Insert Sleeve.....16-3/4"14"1/2"13"25-3/4"1/2"The bottom edge of the insert sleeve has a 7/8"wide flange on the sides and a 1/2" wide flangeon the front and back.Remote Location for the ControlThe control may be removed from the hoodand installed into a wall or countertop. A 30-ft.length of wire is supplied to accommodate mostinstallations. A blanking plate covers the openingwhen the controls are removed.The overall size of the control is 4-1/4" wide end2-1/4" dee _.1-11116"13-11/16"Control cutoutWe recommend that the cutout in granite or otherhard surfaces be made before the countertop isinstalled.