GE egr3000 Owner's Manual & Installation Instructions

Also see for EGR3000: Owner's manual and installation instructions Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions

GE egr3000 Owner's Manual & Installation Instructions Manual pdf 46 page image

Troubleshooting TipsOperating Instructions Safety InstructionsInstallation InstructionsTroubleshooting TipsConsumer Support46Before you call for service…Problem Possible Causes What To Do“LOCK DOOR” flashes The self-clean cycle has been • Close the oven door.in the display selected but the door is notclosed.LOCKED DOOR light The oven door is locked • Touch the CLEAR/OFF pad. Allow the oven to cool andis on when you want because the temperature then, on models with a door latch, unlock the door.to cook inside the oven has notdropped below thelocking temperature.Oven door will not Oven is too hot. • Allow the oven to cool below locking temperature.unlock (on models Do not lock the door with the door latch except whenwith a door latch) using the self-clean feature.“Door” appears in the Self-cleaning cycle has been • Move the latch handle all the way to the right.display (on models selected but the latch handlewith a door latch) was not moved all the wayto the right.Latch handle was moved to the • Move the latch handle to the right only when settingright but a program other than the self-cleaning cycle.self-cleaning was selected.“F—and a number or On models with a door latch, • The latch may have been moved, even if only slightly,letter” flash in the display if a function error code appears from the locked position. Make sure the latch is movedduring the self-cleaning cycle, to the right as far as it will go.check the oven door latch.You have a function error code. • Touch the CLEAR/OFF pad. Allow the oven to cool forone hour. Put the oven back into operation.If the function code repeats. • Disconnect all power to the range for 5 minutesand then reconnect power. If the function errorcode repeats, call for service.Display goes blank A fuse in your home may be • Replace the fuse or reset the circuit breaker.blown or the circuitbreaker tripped.The clock is in the • See the Special features of your oven control section.black-out mode.Display flashes Power failure. • Reset the clock.Unable to get the Oven control pads were • The BAKE and BROIL HI/LO pads must be touched atdisplay to show “SF” not touched properly. the same time and held for 3 seconds.Power outage, Power outage or surge. • Reset the clock. If the oven was in use, you must resetclock flashes it by touching the CLEAR/OFF pad, setting the clock andresetting any cooking function.Oven shelves are The nickel shelves (if so equipped) • Apply a small amount of vegetable oil to a paperdifficult to slide were cleaned in a self-clean cycle. towel and wipe the edges of the oven shelves withThe gray porcelain-coated shelves the paper towel. Do not spray with Pam® or other(if so equipped) were improperly lubricant sprays.cleaned.