Gabarron RF4P Installation Instructions And User Manual

Also see for RF10E: Installation instructions and user guide Installation instructions and user guide

Contents

Gabarron RF4P Installation Instructions And User Manual Manual pdf 6 page image

WEEKLY PROGRAMMESIt is possible to allocate different programs to different days of the week. To do this, the controller has to be upgrade from 24hr mode (factorydefault) to 24hr/7days mode as follows:Move the selector to 0 position, the display will be Off. Press the key and at the same time turn the selector to P position maintaining thekey at least five seconds. The display will show P-SE which means that weekly mode has been set.SETTING THE DAY: Press the key more than two seconds and the display will show the number of the day. Set the correct number, ifrequired, by pressing + or – keys. Press the key and the display will show now the time. Press again the key and new values will bestored.To check a programme or to make a new one press PRG key: The display will show dia1 . Press again PRG key and the display willshow 00:00 intermittently. Follow now the steps from DAILY PROGRAMMES section until the display shows again dia1 . Repeat thisprocess with the 7 days of the week. When the display shows dia7 the weekly program will be stored by pressing + key.If the display shows dia1 then, pressing + key more than three seconds will copy the day 1 program to day 2 and so on.It is possible to allocate any of the three temperature levels to all the intervals of any day maintaining the relevant 7 keyuntil an audible signal is heard.To turn back a controller from 24hr/7days to a single 24hr press PRG key more than six seconds. This will restore the factory default settings.KEYBOARD LOCKPress the 7 key more than six seconds and the keyboard will be locked. The display will show and the controller will keep onworking internally. To unlock the keyboard press again the 7 key more than six seconds .4.- CLEANING AND MAINTENANCEClean and dust with a dry, soft cloth only when the unit is disconnected and cold.Do not use solvents or abrasive products for cleaning.This thermal radiator has been manufactured under an assured quality system using environment friendly processes.Please take the heaters to a clean point once their useful life is finished, in order to recycle their materials in the right way.5.- TROUBLESHOOTING- The thermal radiator does not heat. Check the heater or the air inlets are not covered.Digital models: the display shows the time press the 7 key to switch on the heater. Check that theDAY or NIGHT temperatures are right.- The room does not reach the righttemperature. Check the selected temperature is in accordance with the desired temperature. Maybe the room needsmore heating power.- DAY and NIGHT luminous indicatorsare lit at the same time. Digital models: Continuous mode has been selected. Turn the knob to the “P” position to return to theProgram mode if required.- The display shows “Err1” or “Err2” Digital models: Contact the after sale service.- Only daily programmes. The controller is in a single 24hr mode (factory default). See WEEKLY PROGRAMMES section to swiftto 24hr/7days mode.- The keyboard is locked. If the display shows the keyboard is locked. To unlock the keyboard press the 7 keymore than six seconds.

/ 7

Related manuals for Gabarron RF10E