5! Important Safety InstructionsREAD AND SAVE THESE INSTRUCTIONSWARNING: If the information in this manual is notfollowed exactly, fire or shock may result causingproperty damage or personal injury.WARNING: Do not repair or replace any part of theappliance unless specifically recommended in themanuals. Improper installation, service ormaintenance can cause injury or property damage.Refer to this manual for guidance. All otherservicing should be done by a qualified technician.! Appliance Handling SafetyDo not lift appliance by door handle. Remove thedoor for easier handling and installation. Seeinstructions in Use and Care Manual.Unit is heavy and requires at least two people orproper equipment to move.Hidden surfaces may have sharp edges. Usecaution when reaching behind or under appliance.Safety Codes and StandardsThis appliance complies with one or more of thefollowing Standards:UL 858, The Standard for the Safety of HouseholdElectric RangesUL 923, The Standard for the Safety of MicrowaveCooking AppliancesUL 507, The Standard for the Safety of ElectricFansANSI Z21.1-2000, The American National Standardfor Household Cooking Gas AppliancesCAN/CSA-C22.2 No. 113-M1984 Fans andVentilatorsCAN/CSA-C22.2 No. 61-M89 Household CookingRangesIt is the responsibility of the owner and the installerto determine if additional requirements and/orstandards apply to specific installations.! Electric SafetyBefore you plug in an electrical cord, be sure allcontrols are in the OFF position.If required by the National Electrical Code (orCanadian Electrical Code), this appliance must beinstalled on a separate branch circuit.Installer - Show the owner the location of the circuitbreaker or fuse. Mark it for easy reference.Important - Save these instructions for the localelectrical inspector's use.Before installing, turn power OFF at the servicepanel. Lock service panel to prevent power frombeing turned ON accidentally.Refer to data plate for more information.Be sure your appliance is properly installed andgrounded by a qualified technician. Installation,electrical connections and grounding must complywith all applicable codes.! Related Equipment SafetyRemove all tape and packaging before using theappliance. Destroy the packaging after unpackingthe appliance. Never allow children to play withpackaging material.Never modify or alter the construction of theappliance. For example, do not remove levelinglegs, panels, wire covers or anti-tipbrackets/screws.Accessories for installationYou can order the following accessories forinstallation:GZ 010-011: Extension for inlet and outletIf the hardness of the water exceeds 9° (Englishwater hardness), you must install a descalingsystem between the tap and the appliance to reducethe build-up of limescale.Preparing the Cabinet – Figure 1a /1b1 – cold water connection2 – water drain3 – descaling systemFitted units must be heat-resistant up to 200°F,adjacent unit fronts up to at least 160°F.Secure furniture which is not fitted to the wall usinga standard fixture.Install the appliance low enough to allow trays to beeasily removed.Do not install another electrical appliance abovethis appliance in the cabinet.Electrical ConnectionObserve rating plate data for voltage and totalrating.Attach flexible conduit to the junction box.Connect the oven lead wires to the junction boxsupply wires in proper phase. Only connect inaccordance with the connection diagram.en