Gaggenau BS 464 610 Installation Instructions Manual

Also see for BS 464 610: Use and care manual Use and care manual

Contents

Gaggenau BS 464 610 Installation Instructions Manual Manual pdf 7 page image

7Removing PackagingNOTICE: To prevent damage to your floor keep the unitin its packaging base until ready to be placed in thecabinet opening. Do not slide the unit across theflooring.Different models use different packaging materials.Actual brackets may look differently. Bracket remains inpackaging base.1 Cut straps on outside of box.2 Remove cardboard box.3 Remove all top and side cardboard and Styrofoambraces.4 Place oven in front of cabinets where it is to beinstalled.Install ApplianceNote: The appliance is heavy. It is advisable to install itwith a second person.NOTICE: Before installing the appliance, be sure toverify the cabinet dimensions and electricalconnections.Mount to CabinetUse the included retaining plate and two screws tofasten on the side bottom of the hinge side in theinstallation cabinet. Mark the screw midpoint, theretaining plate must be positioned precisely. Dependingon the installation situation, on partition floor or heatingdrawer WS4.., turn the retaining plate by 180°. Whenpushed into the cupboard, the appliance snaps into theretaining plate.If there is no fitted shelf above the appliance, secure theappliance against tipping over when the door is opened.Fit two standard angles 3 / 16 ” (5 mm) above the applianceat 17 3 / 4 ” (450 mm) depth inside the cabinet.1 Do not kink or trap the connecting cable, or route itover sharp edges.2 Centre the appliance.There must be an air gap of 3 / 16 ” (5 mm) betweenthe appliance and adjacent cabinets.3 Using a spirit level, adjust the appliance so that it isperfectly level.