10Required accessories and toolsSupplied accessories– Installation instructions– Operating instructions– Installation kitOptional accessoriesInstallation accessories for Side-by-Side installationFor permanent connection of two individual appliances,e.g. Freezer next to Refrigerator.Lateral additional heatingIf the gap between the appliances is lessthan 6" (160 mm).Connecting element for furniture doorsFor connection of two door panels (see explanation inSection “4. Preparing the furniture doors”). Can be usedfor standard height door panels without furtherpreliminary work.Miscellaneous– Stepladder– Dolly, hand truck– Hammer drill for drilling holes in wall or floor– Bits according suitable for material and in differentsizes– Wooden beam (cross section min. 3" x 4") as analternative tip protection, length according to thewidth of the installation niche– Wooden screws in different sizes– Thin plywood sheet, particle board or cardboard toprotect the floor from damage– Suitable material for covering and protecting furniture(e.g. protective sheets)– Adhesive tapeNote:Before using, check whether the removed adhesivetape leaves adhesive residue on the work surfaces!Otherwise do not use on high-quality work surfaces.ToolsCordless screwdriverT20 Torx-bit magneticholderT20 Torx screwdriver5/ 16 " (8 mm) socketwrenchVarious size drillsOpen end wrench 1 /2 "(SW 13 mm)Multigrip pliersAdjustable wrenchCutter with adjustablebladeMetal tape measure,folding rulerSquare2' (60 cm) and 4' (1 ,2 m)spirit levelsLevel, min. 4' (1 ,2 m) long
