Gaggia 10001699 Operating Instructions Manual

Also see for 10001458: Operating instructions

Contents

Gaggia 10001699 Operating Instructions Manual Manual pdf 14 page image

• 11 •ENGLISHDescription of parts:FIG. 011 Main switch2 Hot water/brew switch (pump)3 On/off light4 Steam switch (temperature)5 Correct temperature light6 Removable water tank7 Steam/hot water knob8 Turbo frother steam nozzle (removeable)9 Filterholder10 “Perfect crema” pod fi lter11 “Perfect crema” filter for ground coffee12 Basin (removable)13 Frothing jet device14 Brewing head15 Filterholder gasket16 Overfl owing protection hole17 Shower disc18 Tamper19 Power cable and plug20 Measuring spoon21 Delivery spout22 Tank cover23 Grid (removable)24 Cappuccino maker kit (OPTION)Instructions for the power supply cordA A short power-supply cord is provided to reduce risks ofgetting tangled up or tripping over a longer cord.B Longer extension cords are available and may be used ifcare is exercised in their use.C If a long extension cord is used:1 the marked electrical rating of the extension cordshould be at least as great as the electrical rating ofthe appliance.2 if the appliance is of the grounded type, the extensioncord should be a grounding-type 3-wire cord, andthe longer cord should be arranged so that it willnot drape over the counter top portable top where itcan be pulled on by children or tripped over;3 If the power supply cord has a polarized plug (oneblade is wider than the other), as a safety feature,this plug will fi t in a polarized outlet only one way.If the plug does not fi t fully in the outlet, reverse theplug. If it still does not fit, contact a qualified electri-cian. Do not attempt to defeat the safety feature.4 If damaged, the power cord must be replaced by themanufacturer or an authorised service centre.Preparation:1. Remove the water tank cover (22) and fi ll the tank withcold water checking the level through the tank windowshown in FIG. 02.N.B.: The upper section of the tank (6) is provided with anoverfl owing safety hole (16) in case of tank overfi lling.The water tank can also be removed (FIG.02), afterremoving the tank cover (22).Re-install tank with water and cover (22).2. Insert plug (19) into a suitable wall outlet (see point 1under “Caution”).3. Press the main switch (1), the start light (3) will light up.The temperature light (5) will light up fi xed when therequired temperature is reached;Circuit PrimingN.B.: Upon first use, after dispensing steam or when thewater tank is empty, the machine’s water circuit mustalways be primed.This machine, featuring a pump to brew coffee, is equippedwith a self-priming system.Place an empty cup under the brewing head (14), do notinsert the fi lter holder and press the hot water/coffee switch(2) (“1 Pos.).You will hear the sound of the operating pump, and after a fewseconds, water will start flowing out of the brewing head (14).Warning! Before removing the water tank,make sure that the machine is off as not todamage the self-primer.When the cup is full,press again the hot water/coffee switch