ENGLISHDescription of parts:FIG. 011 On-Off-switch/Power-on light2 Hot water/brew switch (pump)3 Temperature ready-light4 Steam switch (temperature)5 Drip plate6 Removable water tank7 Steam/hot water knob8 Turbo frother steam nozzle(removeable)9 Filterholder10 1 cup filter (or coffee pod)11 2 cup filter12 Drip tray13 “Perfect crema” device14 Brewing head15 Filterholder gasket16 Shower disc holder17 Shower disc18 Tamper19 Power cable and plug20 Measuring spoon21 Delivery spout22 Tank cover23 Removable decompression duct24 Milk frother (removeable)Instructions for the power supply cordA A short power-supply cord is provided toreduce risks of getting tangled up or trippingover a longer cord.B Longer extension cords are available andmay be used if care is exercised in their use.C If a long extension cord is used:1 the marked electrical rating of the extensioncord should be at least as great as theelectrical rating of the appliance.2 if the appliance is of the grounded type, theextension cord should be a grounding type3 the cable does not hang from the table toavoid the risk of getting caught up in it.Preparation:1. Remove the water tank cover (22) and fillwith cold water to the MAX line indicated ontank (6). See FIG. 2.The water tank can also be removed afterdisconnecting the decompression duct (23)by pulling it down and removing the dripplate (5) and the drip tray (12).IMPORTANT:Once the tank has beenreinserted, ensure that the silicon pipes areinside the actual tank and not tangled orblocked.The decompression duct is again in theoriginal place by pushing it up.2. Insert plug (19) into a suitable wall outlet(see point 1 under “Caution”).3. Turn the power switch (1) to “1”. The power-on indicator light will light up.Make certain that the hot water/coffee switch(2) and that the steam switch (4) are in the“0” position.Starting upThis procedure fills the water boiler with freshwater.This should be done whenever the machine isswitched on.This machine, featuring a pump to brew coffee,is equipped with a self-priming system. Placean empty cup under the brewing head (14), donot insert filter holder and press hot water/coffee switch (2) (pos. “1”).You will hear the sound of the operating pumpand after few seconds, water will start to escapefrom the brewing head (14).• 9 •