ENGLISH• •Description of parts:FIG. 011 Main switch2 Manual dispensing / hot water button3 Steam button4 Dose programming/Coffee dispensing button5 Correct temperature light6 Turbo frother steam nozzle (removeable)7 Filterholder8 1 cup filter9 Filter for pods10 2 cup filter11 Basin (removable)12 “Perfect cream” Filter (OPTION)13 Brewing head14 Filterholder gasket15 Overflowing protection hole16 Shower disc17 Tamper18 Power cable and plug19 Measuring spoon20 Delivery spout21 Tank cover22 Grid (removable)23 Cappuccino maker kit (OPTION)24 Steam/hot water knob25 Removable water tankInstructions for the power supplycordA A short power-supply cord is provided to reduce risks ofgetting tangled up or tripping over a longer cord.B Longer extension cords are available and may be used ifcare is exercised in their use.C If a long extension cord is used:1 the marked electrical rating of the extension cordshould be at least as great as the electrical rating ofthe appliance.2 if the appliance is of the grounded type, the extensioncord should be a grounding type3 the cable does not hang from the table to avoid therisk of getting caught up in it.Preparation:1. Remove the water tank cover (21) and fill the tank withcold water checking the level through the tank windowshown in FIG. 02.N.B.: The upper section of the tank (25) is provided with anoverflowing safety hole (15) in case of tank overfilling.The water tank can also be removed (FIG.02), afterremoving the tank cover (21).Re-install tank with water and cover.2. Insert plug (18) into a suitable wall outlet (see point 1under “Caution”).3. Push the main switch (1). The temperature light (5)will flash until the temperature is reached; when thetemperature is reached the light will remain on.Starting upThis procedure fills the water boiler with fresh water.This should be done whenever the machine is switched on.This machine, featuring a pump to brew coffee, is equippedwith a self-priming system.Place an empty cup under the brewing head (13), do notinsert the filter holder and press the hot water/coffee switch(2) (“1 Pos.).You will hear the sound of the operating pump, and aftera few seconds, water will start flowing out of the brewinghead (13).When the cup is filled press the hot water supply button (2)again.The Gaggia machine is now ready to be used.Warning! Before removing the water tank,make sure that the machine is off as not todamage the self-primer.