• 17 •EnglishKey to Machine Parts (Page 2)1 Control panel2 Water tank lid3 Hot water/steam knob4 Seat for accessories5 Water tank6 Cup holder rest7 Water recovery tray + grill8 Brew unit9 Steam wand (Pannarello)10 Power cord11 Pressurized fi lter holder12 Ground coffee measuring scoop13 Ground coffee fi lter(single piece for 1 or 2 coffee(s))14 Coffee pod fi lter adapter15 Coffee pod fi lter16 ON/OFF button17 "Machine on" indicator lightLight ON = the machine is onLight OFF = the machine is off18 Coffee brew button19 Coffee/water - "Machine ready" indicator lightLight ON = OK for coffee brewing / hot water dispensingLight OFF = temperature is low for coffee brewing / hotwater dispensing20 Steam button21 "Steam ready" indicator lightLight ON = OK for steam dispensingLight OFF = temperature is low for steam dispensing4 INSTALLATIONFor your own and other people safety, carefully followthe "Safety Regulations" indicated in section 3.4.1 PackagingThe original packaging has been designed and manufacturedto protect the machine during transport. We recommend keep-ing the packaging material for possible future transport.4.2 Installation InstructionsBefore installing the machine, read the following safety in-structions carefully:• Place the machine in a safe place;• Make sure children cannot play with the machine;• Do not place the machine on hot surfaces or near openfl ames.The coffee machine is now ready to be connected to the electricnetwork.Note: We recommend washing the componentsbefore using them for the fi rst time and/or af-ter they have not been used for a certain period of time.4.3 Water Tank• (Fig.1A) - Remove the lid from the water tank (2) by liftingit.• (Fig.1B) - Remove the water tank (5).Note: The machine accessories are placed onthe water tank's (5) side.• (Fig.2) - Rinse the tank and fi ll it with fresh drinking watertaking care not to overfi ll.Fill the tank only with fresh, non-sparkling,drinking water. Hot water or any other liquidmay damage the tank. Do not operate the machinewithout water. Make sure there is enough water in thetank.• (Fig.3) - Insert the water tank making sure that it hasbeen properly repositioned in its former seat and thenreposition the lid (2).Make sure that the tank is fully inserted in themachine by pressing it gently up to its limit stop(THE REFERENCE MARK SHOWN IN FIG. 4 SHOULD BECOMPLETELY VISIBLE). This is to avoid water leaks fromits bottom.4.4 Machine ConnectionElectric power may be very dangerous! It istherefore necessary to strictly follow the safetyregulations. Do not use faulty power cords. Faulty cordsand plugs must be replaced immediately by AuthorisedService Centres.The voltage of the appliance has been pre-set by the manu-facturer. Check that the voltage matches the indication on thedata plate at the bottom of the appliance.• Make sure that the ON/OFF button (16) is NOT pressed be-fore connecting the machine to the electric network.• Insert the plug into a wall socket with suitable power volt-age.