Gaggia PLATINUM VOGUE Technical & Service Manual

Also see for PLATINUM EVENT: Operation and maintenance manual Operation and maintenance manual

Contents

Gaggia PLATINUM VOGUE Technical & Service Manual Manual pdf 20 page image

Ideas with Passion42 315.1 Test functionsPlatinum VisionIn the first three seconds after theappliance is switched on, you canenter test mode by pressing the keysin the sequence shown on the left.1/17TALEA Section 05REV00 - August 06On entering test mode, the screenshown in the screenshot opens.Press the next key to move on tosubsequent levels.t.0Software version NextCPU_V01.04.09* * *t.1 - Brewing unit Nextbu_current (mA) = 3bu_home = OFFbu_work = ONbu_present = ONbu_dregdrawer = ONbu_door = ONbu gohomebu goworkbu gostopLevel T1 – brew groupAt this level, brew group gearmotor and associated microswitches function is tested.- bu_current (mA) - indicates current absorbed by gearmotor.- bu_home - indicates state of brew group home position microswitch.- bu_work - indicates state of brew group work position microswitch.- bu_present - indicates state of brew group presence microswitch.- bu_dregdraver - indicates state of coffee grounds drawer presence microswitch.- bu_door - indicates state of side door closed microswitch.- By pressing “bu go home” once, the gearmotor moves the brew group to the home position.- By pressing “bu go work” once, the gearmotor moves the brew group to the work position.- By pressing “bu stop” once, the gearmotor stops the brew group.t.2 - Heating unit Nextboiler_temp (C°) =79.8CupheaterBoiler *Level T2 – heating unitAt this level, you can check heater function and the associated ntc sensor.- boiler_temp (C°) - indicates the temperature of the water heater.- Pressing “cup heater” once will turn the cup warmer on.- Pressing “boiler” once will turn the heater on.Level T3 – hydraulic circuitAt this level, you can test pump, solenoid valve, drip tray/water tank level, milk island and water/steam valve status sensorfunction.t.3Hydraulic circuit Nextflow_meter (p/s) = 0driptray_sens = OFFwaterlevel_sens = ONknob_milk = OFFknob_water&steam = ONknob_closed = OFFmilk island present = OFFcaraffe present = OFFvalve pumpwater*- flow_meters (p/s) - indicates revolutions per second of the hall sensor in the turbine.- driptray_sens - indicates the state of the capacitive sensor reading the water level in thedrip tray.- waterlevel_sens - indicates the state of the capacitive sensor reading the water level in thewater tank.- knob_milk - indicates the state of the water/steam/milk-island knob in the milk position.- knob_water&steam - indicates the state of the water/steam/milk-island knob in the water/steam position.- knob_closed - indicates the state of the water/steam/milk-island knob in the closed posi-tion.