19TROUBLE SHOOTING - SAFETY RULESProblems Causes SolutionsThe machine does not froth milk. The valve located in the cover is dirty. Wash the valve.The LED in the base of Milk Island is red. Firmly push down on the milk jug.Cover components not installed correctly. Check cover assembly.The coffee machine is not ready todispense steam.Check machine operation.Please contact Gaggia customer service for problems not covered in the above trouble shooting section or whena problem cannot be resolved.Never place live parts in contact with water: danger of short circuit! Steam and hot water can cause scalding!I NTENDED USEThe Milk Island is exclusively intended for domestic use.The Milk Island cannot be used alone but must be connected to a preset coffee machine.Do not make any technical changes or use the machine for unlawful purposes since this would create serious hazards!The Milk Island and the coffee machine must only be operated by adults.POWER SUPPLYThe Milk Island is powered by low voltage from the coffee machine to which it is connected by a special electro-hydraulic connector.POWER CONNECTOR (ELECTRO-HYDRAULIC)Never use the Milk Island if the electro-hydraulic power connector is faulty.If damaged, the electro-hydraulic connector must be replaced by the manufacturer or its customer service department.The connector must not come into contact with liquids, wet parts or other substances that could alter the effectivenessof the electrical contacts or cause a short circuit.PROTECTING OTHERSBe sure that no children operate the Milk Island.Children are not aware of the risks linked with electrical appliances.Do not leave the Milk Island packaging within the reach of children.DANGER OF BURNINGNever direct the jet of hot steam and/or hot water towards yourself or others.Always use the appropriate handgrip on the jug.LOCATIONPlace the Milk Island and the coffee machine in a safe place, where it cannot overturned or cause injury.SAFETY RULES