44Help Message Displayed How to Reset the MessageROTATE THE MILK CARAFEDISPENSING SPOUT INTOBREWING POSITIONA beverage with milk has been selected. The machine requires the carafehandle spout to be placed into dispensing positionPress the button "ESC" to cancel the selection.ROTATE THE MILK CARAFEDISPENSING SPOUT INTORINSING POSITIONThe carafe rinse function has been selectedPress the button "ESC" to cancel the selection.PLACE MILK CARAFEIN ITS HOUSINGThe selected operation requires the milk container for brewing. Insert thecontainer in the machine as specified in the manual.Press the button "ESC" to cancel the selection.15/01/1010:38 Perform a descaling cycle on the machineWhen this message is displayed, it is still possible to use the machine, butits correct operation might be compromisedDamages caused by failure to descale the machine are not covered bywarranty.15/01/1010:38 The machine requests the "Intenza" water filter to be replaced with anew one. Replace the filter as described on page 7.The alarm is displayed only if the "Filter Enable" function is set to "ON".(See page 30)Flashing red light Machine in Stand-byThe Stand-by settings can be changedPress the " " button.RESTART TO SOLVETHE PROBLEME XXAn event has occurred which requires the machine restart. Take note ofthe code (E xx) shown at the bottom.Switch off the machine, wait 30 seconds and then switch it on again. Ifthe problem persists, contact the service centremaCHine WarninGS