Galaxy 10655128702 Use & Care Manual

Contents

Galaxy 10655128702 Use & Care Manual Manual pdf 19 page image

Off-taste, odor or gray color in the ice• New plumbing connections? New plumbing connectionscan cause discolored or off-flavored ice,• Ice stored too long? Discard ice. Wash ice bin. Allow24 hours for ice maker to make new ice.• Odor transfer from food? Use airtight, moisture proofpackaging to store food,• Are there minerals (such as sulfur) in the water? A waterfilter may need to be installed to remove the minerals.• Is there a water filter installed on the refrigerator? Gray ordark discoloration in ice indicates that the water filtrationsystem needs additional flushing.The ice dispenser will not operate properly• If the ice storage bin is located on the door, remove thetemporary shield from underneath the ice storage bin. See"Ice Maker and Storage Bin."• Freezer door closed completely? Close the door firmly, If itdoes not close completely, see "The doors will not closecompletely."• Ice bin installed correctly? Be sure the ice bin is firmly inposition.• New installation? Wait 24 hours after ice maker installationfor ice production to begin. Wait 72 hours for full iceproduction.The water dispenser will not operate properly• Freezer door closed completely? Close the door firmly. If itdoes not close completely, see "The doors will not closecompletely,"Refrigerator connected to a water supply and the supplyshutoff valve turned on? Connect refrigerator to watersupply and turn water shutoff valve fully open.Is the water pressure at least 30 psi (207 kPa)? The waterpressure to the home determines the flow from the dispenser.See "Water Supply Requirements."Kink in the home water source line? Straighten the watersource line.New installation? Flush and fill the water system.Water filter installed on the refrigerator? The filter may beclogged or incorrectly installed,Is a reverse osmosis water filtration system connected toyour cold water supply? See "Water Supply Requirements"in either the Installation Instructions or the Use & Care Guide.Water is leaking from the dispenserNOTE: One or two drops of water after dispensing is normal.• Glass not being held under the dispenser long enough?Hold the glass under the dispenser 2 to 3 seconds afterreleasing the dispenser lever.• Ice stuck in the delivery chute? Use a plastic utensil to clearthe delivery chute. •• Has the wrong ice been added to the bin? Use only cubesproduced by the current ice maker.• Has the ice melted around the auger (metal spiral) in theice bin? Empty the ice container. Use warm water to melt theice if necessary,Cut HazardUse a sturdy glass when dispensing ice.Failure to do so can result in cuts.Is the ice dispenser stalling while dispensing "crushed"ice? Change the ice button from "crushed" to "cubed." Ifcubed ice dispenses correctly, depress the button for"crushed" ice and begin dispensing again,Has the dispenser arm been held in too long? Ice will stopdispensing when the arm is held in too long, Wait 3 minutesfor dispenser motor to reset before using again.New installation? Flush the water system, See "Prepare theWater System" or "Water and Ice Dispensers."Recently changed water filter? Flush the water system. See"Prepare the Water System" or "Water and Ice Dispensers."The dispenser water is not cool enoughNOTE: Water from the dispenser is chilled to only 50°F (10°C).• New installation? Allow 24 hours after installation for thewater supply to cool completely.• Recently dispensed large amount of water? Allow24 hours for water supply to cool completely,• Water not been recently dispensed? The first glass of watermay not be cool. Discard the first glass of water.• Refrigerator connected to a cold water pipe? Make surethe refrigerator is connected to a cold water pipe, See "WaterSupply Requirements."19