Page 9CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPENCAUTION: TO REDUCE THE RISK OF FIRE OR ELECTRICALSHOCK,DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTUREAVIS: RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIRC RE PA5 140O X1 2 3 4 02 03 04 0512111098765 SPEAKER OUTPUT73W 8ohms Min.60HZ 250W120V ~50HZ 250W230V ~LINE OUTSERIAL NO.93FLCOMMERCIALAUDIO EQUIPMENT601 E. Pawnee Wichita, KS 67211316.263.2852 www.galaxyaudio.com77G A L A X Y A U D I OSPEAKER OUTPUT1/4” connector output from the internal amplifier.It can supply an external 8 ohm speaker with 73watts of RMS power. This means two 16 ohmHOT SPOTS can be connected to the systemwithout overloading the amplifier; great for a smallPA or monitor setup.LINE OUTRCA jack -10dB line level outputcan be fed to a recorder, or to othersound system components. It ispost-EQ, pre-compressor andpre-amplifier.CONNECTORS/INDICATORS and their operation(Rear Panel)POWER CORDEffects devices for microphones or a second instrument may be fedinto one input while an instrument, CD player or tape deck isfed into the other.POWER SWITCHTONE CONTROLSWhen all three controls are set tothe 12 o’clock (detent) position,the output frequency response is flat.MIC (XLR) INPUTBalanced input with 24 VDCphantom power for electretmicrophones.POWER LEDLIMIT LEDIndicates when the built-in compression circuit is activated. By automatically reducing gain before clipping occurs thecompression circuit prevents distortion. The LIMIT LED remains lit about half the time when the amplifier is being drivento its maximum potential. Do not allow it to remain lit more than half the time.HIGH +/- 12dB shelving at 15 kHzMID +/- 10dB peak/dip at 2 kHzLOW +/- 10dB peak/dip at 300 HzThe PA5X (POWERED HOT SPOT)CONTROLS/INDICATORS and their operation (Front Panel)DLEVEL CONTROL FOR MIC (XLR) INPUTLEVEL CONTROL FOR 1/4" INPUT1/4" INPUT