Galil Motion Control RIO-47 series RIO-47100 User Manual

Galil Motion Control RIO-47 series
RIO-47100 User Manual Manual pdf 100 page image

Jumper DescriptionsRIO-4710x/4712xJumper Label Function (If jumpered)J5 MRST Master Reset enable. Returns RIO to factory default settings and erases non-volatile memory. Requires power-on or RESET to be activated.UPGD Used to upgrade the controller if the unit becomes unresponsive.19.2 Set baud Rate to 19.2k (default without jumper is 115k)OPT 10BaseT Ethernet CommunicationJumper Label Function (If jumpered)JP6 EXT (4jumpers)Power for board comes from external power source, see Step 2. ConnectPower to the RIO and Power Requirements for EXT/AUX Power Option.JP7 PoE (4jumpers)Power for board comes from Power over Ethernet (No power cable isnecessary – Ethernet cable with PoE Switch is required)Jumper Label Function (If jumpered)JP102 INC Connects INC0 & INC1 to +5V and INC0B & INC1B to GNDJP102 OUTC Connects OP1A to GND and OP1B to +5VRIO-47142Jumper Label Function (If jumpered)J6 MRST Master Reset enable. Returns RIO to factory default settings and erases non-volatile memory. Requires power-on or RESET to be activated.UPGD Used to upgrade controller if the unit becomes unresponsive.19.2 Set baud Rate to 19.2k (default without jumper is 115k)OPT 10BaseT Ethernet CommunicationRIO-472xxJumper Label Function (If jumpered)JP5 MRST Master Reset enable. Returns RIO to factory default settings and erases non-volatile memory. Requires power-on or RESET to be activated.UPGD Used to upgrade controller if the unit becomes unresponsive.19.2 Set baud Rate to 19.2k (default without jumper is 115k)OPT 10BaseT Ethernet CommunicationJumper Label Function (If jumpered)JP6 AUX(4 jumpers)Power for board comes from external power source, see Step 2. ConnectPower to the RIO and Power Requirements for EXT/AUX Power Option.PoE(4 jumpers)Power for board comes from Power over Ethernet (No power cable isnecessary – Ethernet cable with PoE Switch is required).Jumper Label Function (If jumpered)JP3 INC Connects INC0 & INC1 to +5V and INC0B & INC1B to GNDRIO-47300Jumper Label Function (If jumpered)JP5 MRST Master Reset enable. Returns RIO to factory default settings and erases non-volatile memory. Requires power-on or RESET to be activated.UPGD Used to upgrade controller if the unit becomes unresponsive.19.2 Set baud Rate to 19.2k (default without jumper is 115k)OPT 10BaseT Ethernet CommunicationJumper Label Function (If jumpered)Appendix ▫ 100 RIO-47xxx Rev. 1.0r