Garbin TZ OPTIC FIBER 400 Use And Maintenance Manual
                                       | |
Contents
| 
Use and maintenance manualRev. 02/18 - UKVia Leonardo da Vinci, 32/B36034 Malo (VI) Italia 19TZ OPTIC FIBER 400 INNOMINABILEDescription of the controls on the control panel of theengine hood (Fig. 9):15) Engine tachometer and working hour meter.16) Fuel level17) Temperature indicator of the engine water.18) Fault of the engine / engine off.19) Indicator reporting the fuel reserve.20) Engine alternator warning light.21) Engine oil pressure.22) Light indicator reporting the plugs preheating.23) Consent to the radio control.24) Engine temperature warning light.4.2 ON WORK4.2.1 PRECAUTIONS BEFORE START-UPWARNING‘Section 2’ describes the general safety standards.In addition to the information shown in this sec-tion,it is essential that the operator reads and storeswhat described below.• The start-up of the machine must be on levelground and with disc raised.• During the handling of the machine (even for shorttrips), it is mandatory to keep the tootheddisc lifted from the ground (at least 10 cm from-theground) so as to ensure the stability of the-machine.• Use extreme caution during refueling opera-tions.Avoid filling the tank with the engine run-ning. Avoidsmoking or open flames. Do not o-verfill the tank. Ifthis happens, wipe immedia-tely. If necessary, usea funnel to avoid drips. Carefully tighten the cap ofthe tank when the supply is completed.• It is not recommended to use the machine in-doors, but, if it was really necessary, before startingthe machine make sure there is adequa-te ventila-tion.Exhaust fumes can kill.• Before starting, check all the tools, indicators andwarning lights. Check all safety devices ma-kingsure that everything is working properly.• Adjust the speed according to the ground con-ditions. Watch out for obstacles. Bypass any rocksand stumps.• Avoid crossing rails, excavations, crests or edges.If the crossing cannot be avoided, slow down andproceed with a certain angle than the obstacle. A-void yielding docks, potholes and steep slopes.• During operation, the machine can throw sto-nesand/or blunt objects to a certain distance.Remove any objects or pets that are within ran-geof the machine.• Starting a new dig, move the excavation disc withextreme caution. The speed of the tool must be re-duced.Fig. 9 - Control panel on the bonnet |
Related manuals for Garbin TZ OPTIC FIBER 400
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine