Gardena 380 EC Operating Instructions Manual

Contents

16GBDeposits affect the cutting result as well as discharge of grass clip-pings. Residual dirt and grass is easily removed immediately aftermowing.1. Remove grass deposits with a brush and a cloth.2. Oil the red cutting mechanism lightly with thin oil (e.g. sprayedoil).8. Troubleshooting / ServiceDANGER ! Cutting tool can cause injuries !V Before rectifying faults, wait for the cutting tool tostop, wear suitable work gloves and pull out themains plug.Problem Possible cause RemedyAbnormal noise, Screws / components loose. v Tighten screws or sendClattering in the mower to GARDENA Service.Foreign bodies on the blade. v Remove foreign bodies.Notch in the blade. v Remove notches withgrindstone.Blades are striking each other v Adjust cutting mechanism.too hard.Motor will not start Power cable faulty. v Unplug from mains andcheck power cable.Fuse / fault current Check power cable andcircuit-breaker has replace fuse / switch faultresponded. current circuit breakeron again.Extension cable may not have a v Use extension cable withlarge enough cross-section. cross-section complying withtable (2. Safety references).Circuit breaker has been v Wait approx. 5 -10 minutestriggered. then turn on the moweragain.Motor jams and is noisy Blocked by foreign body. 1. Release starting handle.Blocking protection activated. 2. Unplug mains plugat the socket.3. Remove foreign body.Cutting load too high. v Reduce mowing speed and /or raise cutting height.Motor turns off The cutting height you have Let the motor cool for 5 -10 min-selected is too low; utes, then use the mower withCircuit breaker has been a higher cutting height andactivated. reduce the cutting height andthe mowing speed in stages.Runs unevenly, mower Cutting tool damaged. v Have cutting tool checkedvibrates significantly by an authorised specialistdealer or GARDENA-Service.Blade very dirty. v Clean blade.Cleaning the mower :