Gardena 5500/3 Operating Instructions Manual

Also see for 5500/3: Operator's manual Operating instructions Operating instructions Operating instructions

Contents

Gardena 5500/3 Operating Instructions Manual Manual pdf 4 page image

1514GBGB Fault Possible cause Remedy8. Technical Data5500/3 (Art. 1461) 6000/4 (Art. 1468)Mains voltage /mains frequency 230 V / 50 Hz 230 V / 50 HzRated power 900 W 1,000 WMax. delivery capacity 5,500 l/h 6,000 l/hMax. pressure 3.0 bar 4.0 barMax. delivery height 30m 40mMax. submersion depth 12m 12mPower cable 15m H07 RNF 15m H07 RNFPump connection 33.3mm (G 1 female thread) 33.3mm (G 1 female thread)Minimum submersion depthon commissioning 50mm 70mmMin./ max. cut-in height 430mm / 660mm 450mm / 680mmMin./ max. cut-out height 115mm / 210mm 135mm / 230mmResidual water level 25mm 25mmWeight approx. 9.6 kg 10.0 kgFastening rope length 15m / Ø 5mm length 15m / Ø 5mmMax. media temperature 35 °C 35 °C9. Available accessoriesGARDENA 2- / 4-Way Valve For parallel connection for more thanone hose or connected devices.Art. 8193 / 8194GARDENA Fitting 3/4" For 19mm (3/4") hoses. Art. 1723GARDENA Fitting 1" For 25mm (1") hoses. Art. 1724GARDENA For 13mm (1/2") hoses via the Art. 1750Pump Connection Set GARDENA Connection System.GARDENA Tap Connector For 16mm (5/8") hoses via the Art. (2)902GARDENA Hose Connector GARDENA Connection System. Art. (2)916GARDENA For 19mm (3/4") hoses via the Art. 1752Pump Connection Set GARDENA Connection System.For any other malfunctions please contact the GARDENA service department.Repairs must only be carried out by GARDENA service departments or specialistdealers authorised by GARDENA.v Unplug the mains plug andclean the suction foot valve(see 6. Maintenance).Suction foot / inlet screensclogged.Delivery rate suddenlydecreases.6. MaintenanceDo not use any corrosive or abrasive cleaning media.1. Unscrew the 4 screws 8 with a screwdriver.2. Remove the suction foot valve 9 with inlet screen from thepump and clean it.3. Attach the suction foot valve with the inlet screens 9 to thepump and tighten the 4 screws 8 with washers 0.7. TroubleshootingFault Possible cause Remedyv Disassemble check valve andclean (see 3. Initial operation).Check valve jammed.v Check fuses and electricalplug-in connections.Power supply interrupted.v Unplug the mains plug andclean the suction foot valve(see 6. Maintenance).Observe max. mediatemperature (35 °C).Pump overheated:Thermal protection switchswitched pump off due tooverheating.v Unplug the mains plug andclean the suction foot valve(see 6. Maintenance).Suction foot / inlet screensclogged.v Submerge pump deeper(see 8. Technical Data /Minimum submersion depthon commissioning).When starting the pump,water height falls below themin. water level.v Unplug mains cable andplug in again.Air cushion in suction foot.v Open pressure line(e. g. bent pressure hose).Air cannot escape as thepressure line is closed.The pump does notdeliver any water.DANGER! Electric shock!There is a risk of injury from electric shocks.v Before eliminating faults, disconnect thesubmersible pressure pump from the mains.9 0 8For safety reasons, a damaged turbine must only bereplaced by GARDENA Service.DANGER! Electric shock!There is a risk of injury from electric shocks.v Before maintenance, disconnect thesubmersible pressure pump from the mains.Clean suction foot withinlet screen: