11GBThe additional filter can be installed as a pond edge controller foradjusting water features and cleaning the filter housing from theedge of the pond. Water is only drawn in via the additional filter.You can connect the following hoses to the hose connection :. 3 /4” and 1” for FP 750 E / FP 1000 E / FP 1400 E / FP 1800 E /FP 2500 E. 1 1/4” and 1 1/2” for FP 4000 E / FP 5000 E / FP 7500 EFor best results use a hose with the largest possible diameter.1. Remove the cap 3 from the pump.2. Press in snap fastenings 6 andopen up the filter housing 5.3. Push the hose connection 7on to the pump.4. Close filter housing 5.5. Insert hose connection 8 into one filter shell 4 and snapinto the second filter shell 4.6. Press sealing cover 3 on tothe pond edge control 4.7. Connect water feature pumpand pond edge control to ahose.4. Initial Operation1. Place water feature pump on a firm base in such a way that thefilter housing 5 is completely covered by water.2. Pull telescopic pipe 9 out to the desired length.3. Netzstecker in eine Wechselstromsteckdose einstecken.Warning: Pump will start immediately.4. Set the quantity of water required for the water feature using theregulator 0.5. Water bell : Screw insert into the water feature until the waterfeature has produced the shape required.TIP : Install the pond edge controller on a bed of gravel toimprove the water intake. The regulating valve 0 must be fullyopen when using the pond edge controller.1. Fill hose with water to remove any cushions of air in the hose.2. Secure the pond edge controller at the edge of the pond (usingrocks, for example).The pond edge control must be completely covered with water.3. Set the quantity of water required for the water feature with theregulator A.Switch on waterfeature pump :Start pond edge control :VARIANT 2 : Mount the pondedge controller :0A9509543877356