Gardena TCS Li-18 Operating Instructions Manual

Also see for TCS Li-18: Operating instructions Operating instructions

Contents

Gardena TCS Li-18 Operating Instructions Manual Manual pdf 7 page image

Filling in chain oil:0 qwDANGER!Physical injury due to chain breakage when the chainon the bar is not sufficiently lubricated.v Check whether sufficient quantities of chain oil aredelivered prior to each use.We recommend to use Art. 6006 GARDENA Oil or an equivalentmineral chain oil from a specialist supplier.1. Unscrew lid of oil tank 0.2. Fill chain oil into the filler neck q until the viewing window w isfully filled with oil.3. Close the lid of oil tank 0 again.The device must be cleaned thoroughly if oil has been spilled.Checking the oil lubricationsystem: v Point the bar e at a bright wood cutting surface at a distanceof approx. 20 cm. After operating the machine for one minute,clear traces of oil must be visible on the surface.Never let the bar come into contact with sand or soil as thiswill lead to increased wear of the chain.5. OperationWorking positions: The Pole Pruner can be operated in 2 working positions(above/below). To ensure a tidy cutting edge, thick branchesshould be cut in 2 steps (Illustrations similar).max. 4 mmax. 4 mAßßBAbove(thick branches):1. From below, saw thebranch to no morethan 1/3 of the diameter(chain will push towardsthe stop atthe front ßA ).Above(thick branches):2. Cut off the branchfrom above (chainwill push towards thestop at the back ßB ).Below:Cut off from above(chain will push towardsthe stop at the back ßB ).20GB