Garland BH/BA 1500 Instructions For Use Manual

Also see for BH/BA 1500: Service manual Installation and operation manual

-11-090908_Instructions for use RTCS Base- and Wok-Line_E.doc3.6 SH/WO 3500, SH/WO 5000 and SH/WO 80003.7 InstallationThe cooker must always be set up on a clean and even surface (table, base, etc.) at it’sdesignated site. The cooker stands on non-slip rubber pads and is not permanently installed. Itmust be set up in a way that it cannot fall down or move in an uneven position. The conditionsfor the „place of installation" must be guaranteed.CAUTION If the voltage is wrong, the cooker can bedamaged.The installation of the electricity must be fitted by approved installation contractors inaccordance with specific national and local installation in conformity with all safetyregulations. The warning signs and rating plates on the units must strictly be followed.Check and ensure that the supply voltage and the line current matches the specifications givenon the rating plate.Max. tolerance of supply voltage +6/-10 %Supply frequency 50/60 Hz Turn control knob to off position („0“) Connect the unit to the power socket(The unit is delivered completely with mains cable and plug.)The installation is now finished and an operating test must be done according to chapter 4.