7Detailed OperationRemoving a Frequency from User MemoryYou may edit the contents of User memory to remove its stored frequencies when you want to make achange or you receive a “MEM Full” message.1. Press RCL. Turn the Large knob to the User (MEM) frequencies.2. Press MEM. Turn Large knob to show “Remove.”3. Turn the Small knob to choose the frequency to Remove.4. Press MEM to remove the frequency. Or, turn the Large knob to “Abort” and press MEM to cancel andleave memory as it was.Replacing a Frequency from User MemoryYou may edit the contents of User memory to replace its stored frequencies when you want to make achange or you receive a “MEM Full” message.1. Select the desired new frequency with the Large and Small knobs.2. Press RCL. Turn the Large knob to the User (MEM) frequencies.3. Press MEM. Turn Large knob to show “Replace.”4. Turn the Small knob to choose the frequency to Replace.5. Press MEM to replace the displayed stored frequency with the current Standby frequency. Or, turn theLarge knob to “Abort” and press MEM to cancel and leave memory as it was.Assigning an ID to a User FrequencyFrequencies in User (MEM) memory can be given an alphanumeric identifier for your ease of use.1. Press RCL. Turn the Large knob to the User (MEM) frequencies.2. Press MEM and hold it for about two seconds. “Assign ID” and the frequency to be given an ID will bedisplayed.3. Turn the Small knob to select the desired User frequency.4. Press MEM. Six underscored spaces will appear and the first one will flash.5. Turn the Small knob to select characters. Turn the Large knob to move to another space. Continue toselect the desired characters.Removing, Replacing, & ID User FrequenciesRemove 121.50Removing a FrequencyReplace 121.50Replacing a FrequencyAssign ID 124.55Assigning an ID to a User FrequencyAssign ID ATIS__Done ATIS__