SpecificationsApollo SL30 Installation Manual 43NAV R ECEIVER PERFORMANCEVORTSO/JTSO compliance............................. TSO-C40c (DO-196)/JTSO 2C40cApplicable documents .............................. RTCA DO-196Operational class ...................................... N/AAccuracy category.................................... B {-46 o C to + 55 o C }Frequency range ....................................... 108.00 to 117.95 MHz in 50 kHz incrementsFrequency tolerance ................................. 0.0008%Cross modulation products....................... At least 60 dB downReceiver sensitivity .................................. 108 MHz –115 dBm typical117 MHz –117 dBm typicalCourse accuracy ....................................... RTCA DO-196 two sigma limit: 3oSL30 performance: less than 0.5o typicalAudio output............................................. With a 1 kHz tone 30% modulation at least 100 mWoutput into 500 ohm loadsIdent/voice................................................ With 100 mV input, 30% modulation at 1020 Hz,the ident/voice tone ratio shall not be less than15dBAudio response......................................... Less than 6 dB variation from 350 Hz to 2500 HzLOCALIZERTSO compliance ....................................... TSO-C36e (DO-195)/JTSO C36eApplicable documents .............................. RTCA DO-195Operational class ...................................... A {manual landing systems}Accuracy category.................................... B {-46 o C to + 55 o C }Frequency range ....................................... 108.00 to 111.95 MHzFrequency tolerance ................................. 0.0008%Cross modulation products....................... At least 60 dB downReceiver sensitivity .................................. -115 dBm typicalCentering error ......................................... RTCA DO-195 two sigma limit: 6.6% of full scaleSL30 performance: less than 1.0% typical (1.5 mV)Audio output............................................. With a 1 kHz tone 30% modulation at least 100 mWoutput into 500 ohm loadsIdent/voice................................................ With 100 mV input, 30% modulation at 1020 Hz,the ident/voice tone ratio shall not be less than15dB