Garmin Astro 320 Owner's Manual
Also see for Astro 320: Owner's manualQuick start manualGetting started manualReplacement instructionsReplacement instructions
                      | |
Contents
|
3 Replace the battery cover, and turn the D-ring clockwise.4 Hold .5 Select Setup > System > Battery Type.6 Select Alkaline, Lithium, or Rechargeable NiMH.Charging the Dog Collar DeviceNOTICETo prevent corrosion, thoroughly dry the contacts on the collarand the surrounding area before connecting the charging clip.NOTE: Your dog collar device may look different than the devicepictured.You should fully charge the battery before you use the device forthe first time. Charging a fully depleted battery takes about fivehours.1 Snap the charging clip À onto the device Á.2 Plug the small end of the power cable into the mini-USB porton the charging clip cable.3 Plug the power cable into a power source.The status LED is solid red when the collar is charging.4 After the status LED turns solid green, remove the chargingclip from the collar.Turning On the Devices• On the handheld device, hold the power key until theLCD display turns on.• On the dog collar device, hold the power key until the statusLED flashes and the collar beeps.Turning Off the Devices• On the handheld device, hold the power key until theLCD screen turns off.• On the dog collar device, hold the power key until the statusLED turns red.Acquiring Satellite SignalsBoth the collar and handheld device must acquire satellitesignals before you put the collar on your dog. Acquiring satellitescan take a few minutes.1 Go outdoors to an open area.2 Turn on both devices (Turning On the Devices, page 2).3 Select the power key on the handheld device.shows the GPS signal strength.When the collar has acquired satellite signals, the status LEDflashes a double-blink or triple-blink in green.Adjusting the Backlight BrightnessNOTE: The backlight brightness may be limited when thebattery strength is low.Extensive use of screen backlighting can significantly reducebattery life.1 Select .2 Select to cycle through the brightness levels.3 Select ENTER.Fitting the Collar on Your DogCAUTIONDo not spray the device or collar with harsh chemicals includingbut not limited to flea or tick spray. Always ensure that any fleaor tick spray that is applied to the dog is completely dry beforeplacing the collar on the dog. Small amounts of harsh chemicalscan damage the plastic components and collar laminate.Before you can put the collar on the dog, you must pair thehandheld device and collar (Adding a Dog to the Astro,page 3), and acquire satellite signals (Acquiring SatelliteSignals, page 2).1 Position the collar with the VHF whip antenna pointing up, theGPS antenna facing up, and the LEDs facing forward.2 Place the collar around the middle of the dog's neck.3 Tighten the strap so it is snug around the dog's neck.NOTE: The collar should fit tightly and should not be able torotate or slide on the dog's neck. The dog must be able toswallow food and water normally. You should observe yourdog's behavior to verify the collar is not too tight.4 If the strap is too long, cut off the excess, leaving at least3 in. (7.62 cm) to spare.Using the On-Screen KeyboardA keyboard appears when you enter text.• Select , , , and to select a character, and selectENTER.• Select to backspace.• Select to shift.• Select IN or OUT to change the character mode of thekeyboard.• Select Done to save the text and close the keyboard.Dog TrackingThe handheld device allows you to track your dog, using thetracking compass or map. The map displays your location and2 Dog Tracking |
Related manuals for Garmin Astro 320
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine