Garmin BC 40 Owner's Manual

Also see for BC 40: Quick start manual Owner's manual Quick start manual

Contents

Garmin BC 40 Owner's Manual Manual pdf 6 page image

4 Tighten both screws.5 Apply one or two layers of the included adhesive mountingtape to the back of the flat mounting bracket, near the bottom(optional).The mounting tape secures the back of the mounting bracketto your vehicle using double-sided adhesive. This helpsreduce camera vibration, especially if your vehicle does notprovide mounting holes at the bottom of the license plate.You can stack two layers of mounting tape if one layer is notthick enough to stick to your vehicle.NOTE: The mounting tape does not replace the license platescrews. You must fasten the mount and license plate to thevehicle using at least two license plate screws, whether ornot you attach the mounting tape.Vehicle Mount Installation for EuropeInstalling the Mount on Your Vehicle1 Remove the rear license plate and license plate holder fromyour vehicle, and retain the license plate screws to install thecamera mount.2 Place the camera mount against your vehicle, and align theholes in the mount with the license plate mounting holes inyour vehicle.The camera mount provides a variety of holes and slots foruniversal vehicle compatibility.NOTE: You can install the mount in either orientation. If youare installing the mount with the camera at the top of thelicense plate, you must remove, rotate, and reattach thecamera clip (Installing the Camera at the Top of Your LicensePlate, page 2).3 Insert the license plate screws through the mount and intothe mounting holes in your vehicle.4 Fully tighten the screws.Installing the Camera at the Top of Your License PlateWhen the mount is installed on your vehicle, the Garmin logo onthe camera clip must be right-side up. Out of the box, the mountis assembled for installing the camera at the bottom your licenseplate. When installing the camera at the top of your licenseplate, you must remove, rotate, and reattach the camera clip.This allows you to properly adjust the camera angle.1 If you have already installed the license plate fasteners,remove them by prying up the end of each clip using thenotches and sliding them outward.2 Using a Phillips screwdriver, fully loosen the two camera clipscrews .3 Gently pry open the tabs along the outer edge of thecamera clip, and remove the camera clip from the mount.4 Rotate the camera clip 180 degrees, so the Garmin logo isfacing right-side-up.5 Snap the camera clip back into the mount, and tighten bothscrews.Installing Your License Plate into the Mount1 Insert the edge of the license plate behind the tabs along thenarrow edge of the holder, and swing the bottom edge of theplate into the mount.2 Insert the two license plate retainer clips into the slots in theholder, and slide them toward the middle.3 Press the ends of the retainer clips until they click into theholder.2 Installation