Garmin Dash Cam 30 Owner's Manual

Also see for Dash Cam 30: Owner's manual

Contents

Garmin Dash Cam 30 Owner's Manual Manual pdf 8 page image

TIP: You may need to use a coin to remove the end piece.2 Remove the end piece, the silver tip Á, and the fuse Â.3 Insert a new fast-blow fuse that has the same current, suchas 1 A or 2 A.4 Place the silver tip in the end piece.5 Push in the end piece and rotate it 90 degrees clockwise tolock it back into the vehicle power cable Ã.Removing the Camera Mount from theWindshieldThe adhesive mount is intended for a long-term installation andcan be difficult to remove.1 Firmly grip the mount.2 Pull the mount up and away from the windshield, applyingsteady pressure until the adhesive releases from thewindshield or mount.3 Remove all remaining adhesive from the windshield andmount.4 Clean the windshield and mount.You can replace the adhesive on the mount (Replacing theAdhesive on the Mount, page 4).Replacing the Adhesive on the MountYou can replace the adhesive disc on the mount to install thedevice in a new location. Your device includes one extraadhesive mount. Go to https://buy.garmin.com to purchaseadditional adhesive mount.1 If necessary, remove the adhesive from the mount.2 Clean the mount.The mount must be free of dust, wax, oils, or coatings.3 Remove one side of the protective film from the mountadhesive.4 Position the adhesive over the mount.TIP: The adhesive is extremely sticky. Do not touch theadhesive to the mount until the adhesive is properly aligned.5 Press the adhesive firmly onto the mount, and maintainpressure for 30 seconds.6 Install the camera mount onto your windshield (Installing theMount onto Your Windshield, page 1).TroubleshootingMy device is in demo modeIf you start demo mode on your device unintentionally whiledriving, you can continue to drive while in demo mode. Thedevice detects you are driving and disables demo mode afterapproximately 15 minutes. You can also remove demo modefrom your device manually.1 Turn off the device (Turning Off the Device Manually,page 2).2 Remove the memory card (Removing the Memory Card,page 1).3 Insert the memory card into your computer.4 Delete the DCIM/110DEMO folder.5 Replace the memory card into your camera (Installing theMemory Card, page 1).4 Troubleshooting

/ 10

Related manuals for Garmin Dash Cam 30