Garmin EDGE 510 Quick Manual

Also see for Edge 1000: Quick start manual Owner's manual Quick start manual Owner's manual

Garmin EDGE 510 Quick Manual Manual pdf 7 page image

7cHaPter 1: Basic setuPinstall tHe deVicestandard mount1. select a secure location to mount the eDGe® where it does notinterfere with the safe operation of your bike.2. Place the rubber disk 1 on the back of the bike mount. therubber tabs align with the back of the bike mount so it stays inplace.3. Place the bike mount on the bike stem.4. attach the bike mount securely using the two bands 2 .5. align the tabs on the back of the eDGe® with the bike mountnotches 3 .6. Press down slightly and turn the eDGe® clockwise until it locksinto place.out-front mount1. select a secure location to mount the eDGe® device where itdoes not interfere with the safe operation of your bike.2. use the hex key to remove the screw 1 from the handlebarconnector 2 .3. if necessary, remove the two screws on the back side of themount 3 , rotate the connector 4 , and replace the screws tochange the orientation of the mount.4. Place the rubber pad around the handlebar:– if the handlebar diameter is 25.4 mm, use the thicker pad.– if the handlebar diameter is 31.8 mm, use the thinner pad.5. Place the handlebar connector around the rubber pad.6. replace and tighten the screw.7. align the tabs on the back of the eDGe® device with the bikemount notches 5 .8. Press down slightly and turn the eDGe® device clockwise until itlocks into place.releasing the edGe1. turn the eDGe® clockwise to unlock the device.2. lift the eDGe® off the mount.TIP: For the best GPS reception, position the bike mount so the front of the EDGE® is orientedtoward the sky. You can install the bike mount on the stem or the handlebars.NOTE: Garmin®recommends a torquespecification of 7 lbf-in.(0.8 N-m). You shouldcheck the tightness of thescrew periodically.