Garmin Edge 810 Owner's Manual

Also see for Edge 810: Quick guide Owner's manual Quick start manual Quick start manual

Contents

Garmin Edge 810 Owner's Manual Manual pdf 5 page image

IntroductionWARNINGSee the Important Safety and Product Information guide in theproduct box for product warnings and other importantinformation.Always consult your physician before you begin or modify anyexercise program.Getting StartedWhen using your device the first time, you should completethese tasks to set up the device and learn about the basicfeatures.1 Charge the device (page 1).2 Install your device using the standard mount (page 1) orthe out-front mount (page 1).3 Turn on the device (page 2).4 Locate satellites (page 2).5 Go for a ride (page 3).6 Register the device (page 14).7 Upload your ride to Garmin Connect™ (page 7).Charging the DeviceNOTICETo prevent corrosion, thoroughly dry the mini-USB port, theweather cap, and the surrounding area before charging orconnecting to a computer.The device is powered by a built-in lithium-ion battery that youcan charge using a standard wall outlet or a USB port on yourcomputer.NOTE: The device will not charge when outside thetemperature range of 32° to 113°F (0° to 45°C).1 Pull up the weather cap À from the mini-USB port Á.2 Plug the small end of the USB cable into the mini-USB port.3 Plug the USB end of the cable into the AC adapter or acomputer USB port.4 Plug the AC adapter into a standard wall outlet.When you connect the device to a power source, the deviceturns on.5 Charge the device completely.A fully charged battery can run for up to 15 hours before it mustbe recharged.About the BatteryWARNINGThis device contains a lithium-ion battery. See the ImportantSafety and Product Information guide in the product box forproduct warnings and other important information.Installing the Standard MountFor the best GPS reception, position the bike mount so the frontof the Edge is oriented toward the sky. You can install the bikemount on the stem or the handlebars.1 Select a secure location to mount the Edge where it does notinterfere with the safe operation of your bike.2 Place the rubber disk À on the back of the bike mount.The rubber tabs align with the back of the bike mount so itstays in place.3 Place the bike mount on the bike stem.4 Attach the bike mount securely using the two bands Á.5 Align the tabs on the back of the Edge with the bike mountnotches Â.6 Press down slightly and turn the Edge clockwise until it locksinto place.Installing the Out-Front Mount1 Select a secure location to mount the Edge where it does notinterfere with the safe operation of your bike.2 Use the hex key to remove the screw À from the handlebarconnector Á.3 If you want to change the orientation of the mount, removethe two screws on the back side of the mount Â, rotate theconnector Ã, and replace the screws.4 If the handlebar diameter is 26 mm, place the rubber padaround the handlebar.5 Place the handlebar connector around the rubber pad orhandlebar (31.8 mm diameter).6 Replace the screw.NOTE: Garmin® recommends a torque specification of 7 lbf-in. (0.8 N-m). Check the tightness of the screw periodically.Introduction 1