Garmin FUSION Panel-Stereo Spacer Installation Instructions Manual

Garmin FUSION Panel-Stereo Spacer Installation Instructions Manual Manual pdf 1 page image

FUSION®Panel-Stereo SpacerWARNINGFailure to follow these warnings and cautions could result in personal injury, damage to the vehicle or vessel, orpoor product performance.This device must be installed according to these instructions.Disconnect the vehicle's or vessel's power supply before beginning to install this product.CAUTIONContinuous exposure to sound pressure levels over 100 dBA may cause permanent hearing loss. The volume istypically too loud if you cannot hear people speaking around you. Limit the amount of time you listen at highvolume. If you experience ringing in your ears or muffled speech, stop listening and have your hearing checked.Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.NOTICEWhen drilling or cutting, always check what is on the opposite side of the surface.It is strongly recommended that you have your audio system installed by a professional installer to ensureoptimum performance.You must read all installation instructions before beginning the installation. If you experience difficulty duringthe installation, go to www.fusionentertainment.com for product support.What's In the Box• Mounting spacer• Eight 6-gauge, self-tapping stainless steel screws• Six M4, self-tapping black screwsTools Needed• Electric drill• Drill bit (size varies based on surface material)• Screwdriver• Appropriate saw or utility knife to cut surface material• Marine sealant (optional)NOTE: If you use the mounting spacer, you must use the six black screws supplied with the mounting spacer tomount the stereo to the mounting spacer. Do not use the six stainless steel screws supplied with the FUSIONPanel-Stereo.NOTE: For customized installations, additional tools and materials may be needed.FUSION Panel-Stereo Spacer OrientationYou can use the spacer cutout to run the stereo cables over the top of the installation surface or through a holein the installation surface.If you route the cables through a hole in the installation surface, you can rotate the spacer 180 degrees to hidethe spacer cutout from below.GUID-93B219F6-2955-4A1D-AC32-38DCF1B7E2C6 v1March 2018

/ 4

Related manuals for Garmin 010-12753-00