Garmin Fishfinder 160 Owner's Manual

Also see for Fishfinder 160: Specifications

Garmin Fishfinder 160 Owner's Manual Manual pdf 10 page image

2InstallationMounting the TransducerProper transducer installation is key to getting the best performancefrom your new unit. If the transducer lead is too short, extension cablesare available from you GARMIN dealer. DO NOT cut the transducer lead,this will void your warranty.Following are some tips and basic installation instructions for three popu-lar transducers. Detailed installation instructions are provided in the trans-ducer kits.Transom Mount Installation010-10248-00 (depth/temp) Transom Mount Transducer.Do not mount transducer directly in thepath of the prop. The transducer can causecavitation that may degrade the boat's performanceand damage the prop.Make sure that the transducer isbelow water level when the boatis on plane at high speedMount the transducer cable coverwell above the waterline.Transducer should extend 1/8" belowfiberglass hull or 3/8" below aluminum hullApply marine sealant to allscrew threads to prevent waterfrom seeping into the transom.OKMount the transducer parallel with the bottom.DO NOT mount the transducer behind strakes,struts, fi ttings, water intake or discharge ports, oranything that creates air bubbles or causes thewater to become turbulent. It is important thatthe transducer be in calm, non turbulent water foroptimal performance.