Garmin G1000 Cockpit Reference Guide for the Cessna Nav III190-00384-09 Rev. ASECTION 11 – ADDITIONALFEATURES11-15NOTAMs are not available with FliteCharts. TheNOTAM Softkey label appears subdued and is disabled.When no terminal procedure chart is available, thebanner CHART NOT AVAILABLE appears on the screen.The CHART NOT AVAILABLE banner does not refer tothe FliteCharts subscription, but rather the availabilityof a particular airport chart selection or procedure for aselected airport.If there is a problem in rendering the data (such as adata error or a failure of an individual chart), the bannerUNABLE TO DISPLAY CHART is then displayed.Chart OptionsPressing the CHRT OPT Softkey displays the nextlevel of softkeys, the chart options level (Figure 8-35).Pressing the ALL Softkey shows the entire chart onthe screen.Figure 11-24 Airport Information Page, ALL View SelectedPressing the FIT WIDTH Softkey fits the width of thechart in the display viewing area.Pressing the FULL SCN Softkey alternates betweenremoving and replacing the data window to the right.Day/Night ViewFliteCharts can be displayed on a white or blackbackground for day or night viewing. The Day View offersa better presentation in a bright environment.Selecting Day, Night, or Automatic View:1) While viewing a terminal chart press the MeNUKey to display the Page Menu OPTIONS (see Figure11-22).2) Turn the large FMS Knob to highlight the ChartSetup Menu Option and press the eNT Key.3) Turn the large FMS Knob to move to the COLORSCHEME Option (see Figure 11-22).4) Turn the small FMS Knob to choose between Day,Auto, and Night Options.5) If Auto Mode is selected, turn the large FMSKnob to select the percentage field. Use the smallFMS Knob to change the percentage value. Thepercentage value is the day/night crossover pointbased on the percentage of backlighting intensity.For example, if the value is set to 15%, the day/night display changes when the display backlightreaches 15% of full brightness.The display must be changed in order for the newsetting to become active. This may be accomplishedby selecting another page or changing the displayrange.6) Press the FMS Knob when finished to remove theChart Setup Menu.
