Garmin G1000 System Maintenance Manual

Also see for Cessna Caravan G1000: Cockpit reference guide Pilot's guide Pilot's guide Pilot's guide Pilot's guide

Garmin G1000 System Maintenance Manual Manual pdf 83 page image

G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air Page 3-47190-00716-01 Revision 13.34 Aircraft Registration Number EntryNOTEThis section is only applicable to those aircraft that use the GTX 33/33D transponderconfiguration loaded per Section 3.21.1. With PFD1 in configuration mode, select the GTX page group, then select the TRANSPONDERCONFIGURATION page on PFD1.2. The ‘ADDRESS TYPE’ default is ‘US TAIL’. To enter a non-US Mode-S registration numberset the ‘ADDRESS TYPE’ field to ‘HEX ID’.3. Activate the cursor and highlight the ‘MODE S ADDRESS’ field. Use the small/large FMSknobs to enter the US aircraft registration number or other Mode-S registration number.Figure 3-44, Aircraft Registration4. For US registered aircraft, the ‘FLIGHT ID TYPE’ field should be set to ‘SAME AS TAIL’.For other aircraft, the ‘FLIGHT ID TYPE’ field should be set to ‘CONFIG ENTRY’ or‘PFD ENTRY’.NOTEThe CONFIG ENTRY setting requires the Aircraft Registration/ID number to be enteredonce in the ‘FLIGHT ID’ field. The PFD ENTRY setting allows the pilot to enter theAircraft Registration/ID number from the PFD, via the ‘TMR/REF’ softkey.5. After each configuration setting change, press the ENT key to configure the transponders.6. Press the ENT key on PFD1 to acknowledge prompt.7. After completing transponder configuration, deactivate the cursor.