G3X Installation Manual – Engine Sensor Installation and Configuration Page 8-3190-01115-01 Revision EThe Engine inputs being monitored are displayed as gauges on the EIS display (Figure 8-1) and also onthe MFD’s Engine Page.Figure 8-1. EIS Display (Engine Bar)The following list of gauges, (if configured) are specifically required by FAR 91.205 and will always bedisplayed on the EIS display (engine bar). Other gauges will be displayed as space permits based uponhierarchy and user selections.RPM Manifold Pressure Oil TemperatureOil Pressure Coolant Temperature Fuel Quantity8.2 Engine Sensor InstallationNOTEThe following sections contain general guidance on engine and airframe sensorinstallation. This information is provided for reference only. The installer should alwaysfollow any installation guidance and instructions provided by the applicable engine,sensor, or kit-plane manufacturer. Additionally, all installation practices should be donein accordance with AC 43.13-1B.Appendices G, H, I, and J contain interface drawings for sensor installations using the Garmin sensor kits,and for other sensor installations.8.2.1 Garmin G3X Sensor KitsTables 8-2, 8-3, and 8-4 list Garmin sensor kits available for G3X installations. Refer to Sensor Interfacedrawing Figure H-1.1 when installing Sensor Kits K00-00512-00 and K00-00513-00. Refer to SensorInterface drawing Figure I-1.1 when installing Sensor Kit K00-00514-00.Table 8-2. Contents of G3X Sensor Kit, 4 Cylinder Lycoming/Continental (K00-00512-00)Item Garmin P/N QuantityFuel Flow Transducer, EI FT-60 494-10001-00 1Oil Pressure Transducer, Powered, 150 psi, Gage,w/connector, Kavlico P4055-150G-E4A494-30004-00 1Manifold Pressure Transducer, Powered, 30 psi, Absolute,w/connector, Kavlico P4055-30A-E4A494-30004-01 1Type K Thermocouple, Bayonet, CHT, Alcor 86253 494-70000-00 4Type K Thermocouple, 3/8-24 Bayonet, EGT, Alcor 86255 494-70001-00 4RTD, Oil Temperature, UMA 1B3-2.5R 494-70004-00 1Shunt, Ammeter, +/-50mV, 100 amps, UMA 1C4 909-D0000-00 1