System Configuration190-01810-00 GDL 82 TSO Installation ManualRev. 5 Page 7-27.1 GDL 8X Install ToolThe GDL 8X Install Tool provides:• Diagnostics – reports device, system, and faults information• Configuration – allows selection of installation options• System Update – allows upload of software and firmware to the GDL 82 unitGDL 8X Install Tool Requirements:1. To install the GDL 8x Install Tool, administrative rights may be required.2. Laptop or PC to run GDL 8X Install Tool. The laptop or PC requirements:Operating system Windows 7 or laterProcessor speed 850 MHzHard drive free memory 500 MBRAM memory 256 MBWinzip® (or equivalent application) to extract downloaded fileUSB-A USB-B3. USB-A to USB-B adapter cable to interface between a computer USB-A receptacle and the GDL 82 USB-Breceptacle installed in the wiring harness. The cable length should not exceed 16 ft.Figure 7-1 USB-A and USB-B ConnectorsGDL 8X Install Tool Instructions1. Download the GDL 8X Install Tool from the Dealer Resource Center and flyGarmin.com and install.2. Connect the USB-A plug on the adapter cable to the computer.3. With the GDL 82 powered down, connect the USB-B plug on the adapter cable to unit.4. Apply power to unit.5. Start the GDL 8X Install Tool on the computer.6. Select GDL 82.Figure 7-2 GDL 8X Install Tool Selection Page