Garmin GNS 530 Pilot's Manual & Reference

Also see for GNS 530: Pilot's manual Instructions Pilot's guide addendum Pilot's guide addendum Quick reference

Garmin GNS 530 Pilot's Manual & Reference Manual pdf 191 page image

183183appendix dWhat is the correct missed approach procedure? How do I select the missed approachholding point?To comply with TSO specifications, the GNS 530 does not automatically sequence past the MAP.The active-to waypoint sequence to the first waypoint in the missed approach procedure, wheneverthe OBS key is pressed AFTER crossing the MAP. All published missed approach procedures must befollowed, as indicated on the approach plate.To execute the missed approach procedure prior to the MAP (not recommended), select the ActiveFlight Plan Page and use the direct-to key (by pressing it twice) to activate the missed approach portionof the procedure, as described on page 60.How do I re-select the same approach or activate a new approach after a missed approach?After flying all missed approach procedures, you may reactivate the same approach for another attempt from the Procedures Page. Once you have beengiven clearance for another attempt, activate the approach from the Procedures Page by highlighting “Activate Approach?” and then pressing ENT. The GNS530 provides navigation along the desired course to the waypoint and rejoins the approach in sequence from that point on. See page 60 for information onactivating a specific flight plan leg.To activate a new approach for the same airport, select the new procedure from the Procedures Page. To view the Procedures Page, press PROC and rotatethe large right knob to highlight “Select Approach?”. Press ENT and rotate the large right knob to highlight the new approach you want to fly. Press ENTto select the approach, then select the desired transition. Finally, highlight “Activate?” at the bottom right corner of the screen and press ENT to activate thenew approach.To activate a new approach to a different airport, press direct-to and select the desired airport using the small and large right knobs. Press ENT toaccept the selected airport, then follow the steps in the preceding paragraph to select an approach for the new airport. See section 5 for more information onselecting and activating approaches.Do not attempt to reactivate the same approach you’re currently on, prior to crossing the missed approach point (MAP). If you attempt to do so,an alert message (“Are you sure you want to discontinue the current approach?”) appears. If you still proceed with reactivating the ap proach, theGNS 530 directs you back to the transition waypoint and does NOT take into consideration any missed approach pro ce dures.Troubleshooting Q & A,