Page 5-14 500 SERIES INSTALLATION MANUALRev G P/N 190-00181-025.2.15 STORMSCOPE DOWNLOAD DATA Page(Only if 500 Series unit configured for BFG WX-500 Stormscope interface)Select the STORMSCOPE DOWNLOAD DATA Page(see Figure 5-16). This page shows raw datadownloadable from the WX-500. Optional sets of datainclude WX-500 software version, environmentalconditions, configuration, and fault data.Verify that the configuration data is correct as intended.To request which packet of data to display, highlight thedata group title and use the small right knob to select thedesired group.5.2.16 TRAFFIC Page(Only if 500 Series unit configured for BFGSkywatch or Ryan TCAD interfaces)Select the TRAFFIC Page (see Figure 5-17). This pageshows the BFG Skywatch or Ryan TCAD modes ofoperation and current traffic situation.For BFG Skywatch, this page shows:1. The altitude mode—below (BLW), normal (NORM),above (ABV), or unrestricted (UNR)2. The operating mode—standby (STBY) or operating(OPER)3. Current altitude (ALT)4. Altitude limits being imposed (LIM A and LIM B)5. Heading, and barometric (BARO) and radio (RAD)altitude status.For BFG Skywatch (see Figure 5-17), verify that the 500Series unit can change the Skywatch operating mode(STBY or OPER). In standby mode, verify that theSkywatch may be placed in self-test mode by highlighting“Test Mode?” and pressing ENTER on the 500 Series unit.Refer to the BFG Skywatch installation manual for systemcheckout.For Ryan TCAD (see Figure 5-18), this page shows thecurrent shield mode and altitude. Verify that the TCADshield mode may be changed—Ground (GND), Terminal(TML), Standard (STD), En Route (ENR), or Unrestricted(UNR), and that the TCAD is reporting the correct altitude.Refer to the Ryan TCAD installation manual for systemcheckout.Figure 5-16. STORMSCOPEDOWNLOAD DATA PageFigure 5-17. TRAFFIC Page (Skywatch)Figure 5-18. TRAFFIC Page (TCAD)