Page D-8 GTN 625/635/650 TSO Installation ManualRev. C 190-01004-02P1001GTN 6XXCONFIG MODULE POWERCONFIG MODULE GNDCONFIG MODULE DATACONFIG MODULE CLOCKCONFIGMODULE4132REDBLKYELWHTLIGHTING BUS 1 HILIGHTING BUS 1 LO TO AIRCRAFTLIGHTING BUS656462631817NAV/GPSAIRCRAFT POWERAIRCRAFT POWERAIRCRAFT GNDAIRCRAFT GND5A (28 VDC)ESSENTIAL BUSAIRCRAFTGROUND7.5A (14 VDC)20 AWG20197877AIRCRAFT POWERAIRCRAFT POWER 4330AIRCRAFT GNDAIRCRAFT GND 38374440P10035A (28 VDC)ESSENTIAL BUS10A (14 VDC)AIRCRAFT POWERAIRCRAFT GNDCOMLIGHTING BUS 2 LOLIGHTING BUS 2 HI 6142P1004AIRCRAFT POWERAIRCRAFT POWERAIRCRAFT GNDAIRCRAFT GND5251626120 AWG20 AWG AIRCRAFTGROUND20 AWG (5A C/B, 28VDC)18 AWG (10A C/B, 14 VDC)AIRCRAFTGROUND20 AWG (5A C/B, 28VDC)18 AWG (10A C/B, 14 VDC)20 AWG333468571. ALL WIRES 24 AWG OR LARGER UNLESS OTHERWISE SPECIFIED.2. GROUND DESIGNATIONS: SHIELD BLOCK GROUND AIRFRAME GROUND3. ALL POWER LEADS AND GROUND LEADS ARE REQUIRED.4. CONFIGURATION MODULE IS MOUNTED IN THE BACKSHELL OF THE P1001 CONNECTOR.5. CONFIGURATION MODULE HARNESS USES 28 AWG WIRES. CONTACTS SUPPLIED WITH CONFIGURATION MODULEMUST BE USED FOR CONNECTING CONFIGURATION MODULE HARNESS TO P1001.6. OPTIONAL CONNECTION. LIGHTING CAN BE CONTROLLED BY THE INTEGRATED PHOTOCELL, A SINGLE LIGHTINGBUS, OR DUAL LIGHTING BUSES.7. CIRCUIT BREAKER SHOULD BE LABELED AS SHOWN.8. CIRCUIT BREAKER SHOULD BE LABELED AS: “GPS” FOR THE GTN 625/635, AND “NAV/GPS” FOR THE GTN 6509. IF MODIFICATION OF THE HARNESS FROM THE FAN TO THE P1001 CONNECTOR IS NECESSARY, THE MODIFIEDLENGTH MUST NOT BE LONGER THAN 8 INCHES. THE FAN HARNESS PART NUMBER IS 320-00600-00 AND IS SUPPLIEDAS PART OF THE GTN 6XX CONNECTOR KIT.FAN SUPPLIED AS PART OF THE BACKPLATE ASSEMBLY.s10,FAN POWER OUT (12 VDC) 59FAN GROUNDFAN TACH IN 58439 FANREDBLACKYELLOW10Figure D-4. GTN 6XX Power Lighting Configuration Interconnect
