Garmin GTX 320 Installation Manual

Also see for GTX 320: Installation manual Maintenance manual Pilot's guide

Contents

Garmin GTX 320 Installation Manual Manual pdf 18 page image

Page 2-8 GTX 320/320A Installation ManualRev M 190-00133-012.6 Check Existing Coax and Antenna Before Using a GTX 320/320A Adapter in anExisting InstallationCAUTIONBefore using a Narco or Bendix/King Adapter to install a GTX 320/320A into an existinginstallation, the RF coaxial cable, its connectors, and the antenna must be checked to ensure thefollowing:x There must be no corrosion or damage on the coax or its RF connectors that would adversely affectoperation.x The RF attenuation of the coax from the installation rack to the antenna must not exceed 1.5 dB at1090 MHz.x The antenna must not have corrosion, damage, or loose connections.2.7 Installation Using Existing Narco AT 150 Installation RackThe GTX 320 and GTX 320A can be used with an existing NARCO AT 150 Installation Rack by using theNARCO AT 150 Installation Adapter (P/N 011-00292-00). See figure B6 for the NARCO AT 150 Adapterassembly drawing.NOTESGTX 320 units that are at Mod Level 1 must use the Mod Level 1 NARCO Installation Adapter.After Mod Level 1, the GTX 320 sits 0.17" (4.3 mm) closer to the instrument panel. Also, wheninstalling the GTX 320 in an existing NARCO AT 150 rack (using the AT 150 Adapter) and whenthe aircraft has a bus voltage of +28 VDC, make sure the +28 VDC dropping resistor is bypassed.A. Slide the adapter into the rack installation until the jackscrew mates with its nut.B. Turn the jack screw with a 3/32" Allen wrench until the adapter is secure.C. Looking at the bottom of the transponder, make sure the front lobe of the locking mechanism is in avertical position. This can be accomplished by using a 3/32" Allen wrench through the face plate.D. Slide the unit into the rack until the front lobe of the unit touches the rack. Guide pins on the backplate will help properly align the unit in the rack.E. Turn the Allen wrench clockwise until unit is secured in the rack. Continue turning until tight. Donot overtighten the screw.F. To remove the unit from the rack turn the 3/32" Allen wrench counterclockwise until it disengagesfrom the rack.