nϋvi 500 Series Owner’s Manual AppendixChanging the FuseCauTiOn: When replacing the fuse,do not lose any of the small piecesand make sure they are put back in theproper place.If your unit will not charge in yourvehicle, you might need to replace thefuse located at the tip of the vehicleadapter.1. Unscrew the black, round end piece,and remove it.2. Remove the fuse (glass and silvercylinder), and replace it with a 3 Afast‑blow fuse.EndpieceSilver tipFuse3. Ensure that the silver tip is placed inthe black end piece. Screw on theblack end piece.Mounting on YourDashboardUse the enclosed mounting disk to mountyour unit to the dashboard and complywith certain state regulations.CauTiOn: The permanent mountingadhesive is extremely difficult toremove after it is installed.1. Clean and dry the dashboard whereyou are placing the disk.2. Remove the backing from theadhesive on the bottom of the disk.3. Place the disk on the dashboard.4. Remove the clear plastic cover fromthe top of the disk.5. Place the suction cup mount on top ofthe disk. Flip the lever down (towardthe disk).