Garmin StreetPilot GPS Owner's Manual

Also see for StreetPilot GPS: Reference guide Specifications Owner's manual and reference guide

Contents

Garmin StreetPilot GPS Owner's Manual Manual pdf 80 page image

70Appendix EMessages The StreetPilot uses an on-screen message system to alert you to unit operating characteristics. Pressthe ENTER key to acknowledge and return to the page you were viewing.Battery Power is Low - The batteries in your unit are low and no longer capable of supporting unit operation. Install new batteries.Data Card Checksum Failure - There is an error in the unit’s database. Service is required.Data Transfer Complete - The unit has finished uploading or downloading information to the connected device.Leaving Planned Route - You are no longer traveling along the planned route. Make corrections as necessary.Memory Battery Power is Low - The power that sustains user memory is low and should be replaced by an authorized service center as soon as possibleNo Differential GPS Position - The beacon receiver is not communicating with the unit. Go to the ‘Interface’ setup page to view status messages.No Matching Addresses Found - There is no such address in the map information database. Check spelling or number entry and try again.No Matching Intersections Found - There is no such intersection in the map information database. Check spelling and try again.Poor Satellite Reception - The unit cannot receive enough satellite signals to compute a position. Move to a location with a clearer view of the sky.Power Down and Re-init - The unit cannot calculate a position due to abnormal satellite conditions. Turn off and try again at a different location.RAM Failed - The unit has detected a failure in its internal memory. If the message persists, service is required.Receiver Has Failed - The unit has detected a failure. “Power Down and Re-Init: message will appear. If problem persists, service is required.Received Invalid Waypoint -A waypoint was received during upload transfer that has an invalid identifier.Degraded Accuracy - Accuracy has been degraded beyond 500 meters due to poor satellite geometry or data quality. Use other sources to verify position.Oscillator Needs Adjustment - The unit has detected excessive drift in its internal crystal oscillator. Take the unit to an authorized service center.ROM Failed - The permanent memory has failed and the unit is not operable. Service is required.Route Memory Full - No additional waypoints can be added.Route Waypoint Was Deleted - The waypoint being deleted was part of a route. The waypoint is removed from the route and waypoint memory.Speed Warning - Your current speed has exceeded the speed alarm setting.Stored Data Was Lost - All waypoints, routes, time, and almanac data have been lost due to battery failure, or the receiver’s memory has been cleared.Too Many Turns - You have entered more turns in the route than the memory can hold. Restructure your route.Unknown Data Card Format - The unit does not recognize the format for the Map Data information you are downloading. Check data and settings.Using Sim for Faster Data Transfer - While using a MapSource program, simulator mode is automatically selected to speed data transfer.Waypoint Memory Full - All 100 personal waypoints have been assigned.