Garmin VECTOR 3 Owner's Manual

Contents

Garmin VECTOR 3 Owner's Manual Manual pdf 12 page image

TroubleshootingUpdating the Vector Software Using the Edge 520,820, 1000, or 1030Before you can update the software, you must pair your Edgedevice to your Vector system.NOTE: The left pedal receives the software update. The leftpedal sends the update to the right pedal.1 Send your ride data to your Garmin Connect account.Garmin Connect automatically looks for software updatesand sends them to your Edge device.2 Bring your Edge device within range (3 m) of the sensor.3 Rotate the crank arm a few times.The Edge device prompts you to install any pending softwareupdates.4 Follow the on-screen instructions.Resetting the Vector PedalsIf the device stops responding, you may need to reset it bydisconnecting and reconnecting the battery cover. This does noterase any of your data.1 Use a 4 mm hex key to remove the battery cover À.2 Replace the cover.NOTE: Do not damage or lose the O-ring gasket.3 Use a 4 mm hex key to tighten the battery cover.The pedal LED flashes red once.Performing a Static Torque TestNOTICEThe static torque test is intended for advanced cyclists andinstallation experts. This test is not required under normalcircumstances to achieve good results with the Vector system.This test is available for compatible Edge devices.Garmin recommends performing the static torque test aminimum of three times and averaging the reported torquevalues.1 Go to www.support.garmin.com.2 Enter your product name.3 Enter "torque test" to view the FAQ topic.Following repeated static torque tests, if the reported torquevalue is consistently different than the expected value, you canenter a scale factor for one or both pedals. The scale factor isstored in the pedal and adjusts the power value that iscalculated on the pedal. The scale factor is sent to the Edgedevice and stored on Edge device.8 Appendix

/ 14

Related manuals for Garmin VECTOR 3