Garmin VIRB Elite Owner's Manual
Also see for VIRB Elite: Quick start manual
                | |
KeysSelect to scroll through menus and settings.Select to scroll through menus and settings.OK Select to choose menu options or to take a photo.MODE Select to scroll through modes.Hold to turn the device on and off.REC Slide toward the lens to record video.Mounting the DeviceNOTICETo prevent product loss or damage, do not use the adhesivemounting base when the temperature is below 5°F (-15°C).The permanent mounting adhesive is extremely difficult toremove after it is installed.Before you can install the adhesive mounting base onto asurface, the ambient temperature must be from 70° to 100°F(from 21° to 38°C).Your device includes an assortment of mounting bases andarms, which can be used in many configurations. Theseinstructions provide an example of one possible configuration.You can also purchase additional mounts for your device, suchas wearable mounts, vehicle mounts, or a tripod mount. Go towww.garmin.com/outdoor for more information.NOTE: By default, the camera should be mounted with thescreen facing up to record correctly oriented video. You canadjust the settings to record with the screen facing down(page 4).1 Thoroughly clean the mounting surface using water oralcohol.The mounting surface must be free of dirt, debris, wax, orcoatings.2 Remove the film from the adhesive mounting base À, andpress the base firmly onto the mounting surface.You can use either the flat base or the curved base,depending on the contour of the mounting surface.3 Allow the base to bond to the mounting surface for at least24 hours.4 Place the coupler Á into the base.5 Place the threaded ring  over the coupler, and tighten itonto the base.6 Snap the mounting arm à into the coupler.7 Insert a thumbscrew Ä into the larger opening of the joint,and tighten the thumbscrew to lock the angle of the joint.8 Snap the camera mount Å into the top of the mounting arm.9 Insert a thumbscrew into the larger opening of the joint, andtighten the thumbscrew to lock the angle of the joint.10Place the tab Æ on the back of the camera mount into theslot in the back of the camera.11Squeeze the buttons Ç on the sides of the mount, press thefront of the camera È down, and release the buttons.The camera should be held tightly and should not move inthe mount when properly secured.12If the camera feels loose in the mount, press the front of thecamera into the mount until it clicks.Turning On the DeviceSelect .Turning Off the DeviceNOTICETo prevent loss of data, always turn off the device beforeremoving the battery.NOTE: You cannot turn off the device while recording video.1 If necessary, slide REC away from the lens.2 Hold .appears on the screen while the device saves track log dataand turns off.2 Introduction |
Related manuals for Garmin VIRB Elite
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine