Garmin Vector Quick Start Manual

Also see for Vector: Owner's manual Quick start manual

Contents

1Getting Started WarninGRead all instructions carefully before installing and using the Vector ™ system.Improper use could result in serious injury.See the Important Safety and Product Information guide in the product box forproduct warnings and other important information.noticeGo to www.garmin.com/vectorowner for the latest information including bikecompatibility, software updates, and video tutorials.Tools needed• 15 mm pedal wrench• Bike grease• 3 mm and 4 mm hex keysinstalling Vector ComponentsPreparing the Crank arms1 Remove the existing pedals.2 Clean the threads and remove old grease.Determining Pedal Pod ClearancenoticeThe pedal pod should contact the crank arm only at its mounting face, becausethis is the load-bearing connection. If the pedal pod contacts the crank armanywhere else, the pedal pod may fracture when the pedal is tightened.• If the mounting face ➊ surrounding the threaded hole in the crank arm isrecessed, use one or more washers ➋ to fill the recess.• Make sure the pedal pod mounting face ➌ contacts the crank arm only at itsmounting face (or the washer used to fill the recess).If the pedal pod touches the crank arm anywhere else, use another washerto provide the necessary clearance.• If the mounting face of the crank arm is protruding, do not use washers.Determining the Bicycle Chain ClearanceBefore you can install the right pedal, you must confirm bicycle chain clearance.Move your bike chain to the largest crank gear and the smallest cassettegear.The bike chain should be in the outermost position to determine properclearance between the pedal pod cable and the chain.nOTE: There should be at least 5 mm clearance ➍ between the chain andthe crank arm.➍installing the Pedal Pod and PedalnOTE: The left and right pedal pods are the same.1 Install the left pedal first.2 Apply a thin layer of grease on the pedal spindle ➎ and the pedal pod ➏where it contacts the pedal spindle.➎➑➐➒➏3 On the pedal spindle, stack the pedal pod and any required washers ➐.nOTE: You must carefully bend the cable ➑ out of the way.4 Insert the spindle into the crank arm ➒.5 Hand tighten the spindle.nOTE: The left pedal tightens counter clockwise. The right pedal tightensclockwise.TiP: Power and cadence calculations are not impacted by the orientationof the pedal pod. Garmin recommends placement of the pedal pod on theleading edge of the crank. When the crank is in the forward position, thepedal pod should be pointing downward.Quick Start Manual ................................................................... 1Manuel de démarrage rapide ................................................... 3Manuale di avvio rapido ........................................................... 5Schnellstartanleitung ............................................................... 7Guía de inicio rápido ................................................................ 9Manual de início rápido .........................................................11Snelstartgids ........................................................................... 13Lynstartvejledning .................................................................. 15aloitusopas ............................................................................. 17Hurtigstartveiledning ............................................................. 19Snabbstartshandbok .............................................................. 21Skrócony podręcznik użytkownika ....................................... 23