2 zūmo 200 Series Owner’s ManualAppendixChanging the FuseNoticeWhen replacing the fuse, do not lose anyof the small pieces and make sure theyare put back in the proper position. Thevehicle power cable does not work unlessit is assembled correctly.If your unit will not charge in yourvehicle, you might need to replace thefuse located at the tip of the vehicleadapter.1. Use a coin to push down the silver tip,and turn the coin counter‑clockwise,one‑quarter turn.2. Remove the end piece, the silver tip,and the fuse.3. Install a 1 A fast‑blowfuse of the same size.4. Ensure that the silvertip is located in theend piece. Using acoin, replace the endpiece.Mounting on YourDashboardNoticeThe permanent mounting adhesive isextremely difficult to remove after it isinstalled.Use the enclosed mounting disk to mountyour unit to the dashboard and complywith certain state regulations.1. Clean and dry the dashboard whereyou are placing the disk.2. Remove the backing from theadhesive on the bottom of the disk.3. Place the disk on the dashboard.4. Remove the clear plastic cover fromthe top of the disk.5. Place the suction cup mount on top ofthe disk. Flip the lever down (towardthe disk).EndpieceSilver tipFuse