Garrett AT Gold Owner's Manual

Also see for AT Gold: Owner's manual

Garrett AT Gold Owner's Manual Manual pdf 6 page image

8 Garrett Metal Detectors AT Gold ™ 9ASSeMBly1. Holding the upper and lower stem assembly in front of you (asshown below), twist camlock to the right (clockwise) to loosen.2. Slide lower stem out to engage spring clips in upper stem holes.3. Align the holes in the mounting washers with the small posts onthe lower stem and press firmly into place.7. Depress the spring clip in the S-stem (containing control housing)and insert S-stem through the upper camlock collar into theupper stem.8. The spring clip must be engaged in the FIrST stem opening inorder to maintain battery compartment access. Hand-tightenthe camlock collar. Do not overtighten!9. Depress the spring clip in the lower stem and adjust to the mostcomfortable operating length. Hand-tighten the lower stemcamlock collar. Do not overtighten!10. Wrap the cable snugly about the stem with the first turn of thecable over the stem.11. Insert the coil connector into the 4-pin connector of the controlhousing and hand-tighten. After lining up the connectorpins, press the connector in firmly, yet carefully, until the O-ringis felt to be fully inserted.Note: If the O-ring is properlyseated, the connector's collarcan be easily tightened; if thecollar is difficult to turn, theO-ring may not be seatedproperly.4. Slide the searchcoil onto the stem.5. Insert the threaded bolt through the holes of the lower stem andsearchcoil. Hand-tighten searchcoil assembly with the wing nut.6. Holding assembly as shown, loosen camlock at the end of theupper shaft by turning counter-clockwise.Note: If the camlock collar slides off during loosening, simplyslide it back on and tighten slightly.1. 2. 3.4. 5. 6.7. 8. 1st pin position9. 10.11.